
ENG
4
Portable Radio
iMicro SD card slot
j AUX: 3.5 mm mini-jack for audio signal connecting (phone, MP3 player, etc.)
kPlayer indicator
lBattery charge process indicator
mDC 5V: micro USB jack for charger connecting radio to laptop/PC USB port
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the application.
Battery charging
• Connect radio to a USB port of PC or USB charger using micro USB to USB cable
(included). During battery charging the indicator lis red. Indicator l goes out when the
battery is charged.
• The battery is used in the radio as an integral part of the device, therefore do not try
to extract or replace it, because this can result in the warranty cancellation or the device
damage.
OPERATION MODES
Bluetooth mode
• Wireless data transfer via the Bluetooth protocol enables to connect radio to compatible
devises. Maximum radius of action of data transfer is 10 m. Such obstacles as walls or
other electronic devices can interfere with the signal transfer.
• Turn on the radio and select Bluetooth mode. To do this, move the mode selection knob
f to the highest position. If necessary (switching from USB/microSD), additionally press
the MODE c button on the front panel, a sound confirmation of the selected mode will
be heard.
• It is necessary to select the search mode of devices with Bluetooth on a signal source
(telephone, notebook, smartphone, etc.). «SVEN SRP-500/SRP-505» massage will be
displayed on the screen which is to be connected to*.
• When connection is successful, there will be a short beep**.
Player mode
Attention! The file system of a micro SD carrier is FAT32. Maximum volume is 32 GB. It is
not recommended to use the micro SD Ultra Speed.
• Insert the USB flash or micro SD carrier into appropriate slot, if the radio is in turned
on position and MUSIC mode is on, the playback will start automatically. Playback/Pause
modes are switched over with the help of the button d. Tracks can be controlled by
buttons a(previous track) and b(next track).
* You might have to enter «0000» code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second
search mode activation is not obligatory. Choose the item name «SVEN SRP-500/SRP-505»
and the «connect» command on the source.