
Portable Radio
ENG
4
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the application.
Speaker system battery charging
• Connect speaker system to a USB port of PC or USB charger using micro USB to USB cable
(included). During battery charging the indicator mis red. Indicator mgoes out when the battery
is charged.
• The battery is used in the speaker system as an integral part of the device, therefore do not try
to extract or replace it, because this can result in the warranty cancellation or the device damage.
OPERATION MODES
Bluetooth mode
• Wireless data transfer via the Bluetooth protocol enables to connect speaker system to compatible
devises. Maximum radius of action of data transfer is 10 m. Such obstacles as walls or other electronic
devices can interfere with the signal transfer.
• Turn on the speaker into Bluetooth mode, set the hswitch to BT / MP3.
• It is necessary to select the search mode of devices with Bluetooth on a signal source (telephone,
notebook, smartphone, etc.). «SRP-755», massage will be displayed on the screen which is to be
connected to*.
• When connection is successful, there will be a short beep and the indication of the search mode on
speaker system is over**.
Radio mode
• Turn on the speaker into Radio mode – set the hswitch to FM/AM/SW.
Player mode
Attention! The le system of a micro SD carrier is FAT32. Maximum volume is 32 GB. It is not
recommended to use the micro SD Ultra Speed.
• The system will enter the Player mode automatically when a carrier (USB ash or SD card) is
connected to corresponding ports. Use button dto switch between Play / Pause modes. You can
control tracks by using buttons c(previous track) and e(next track).
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search mode
activation is not obligatory. Choose the item name «SRP-755» and the “connect” command on the
source.