UDT-4K UHD HEVC Digital Camera Transmitter
MANUAL V0 7
Important Notes
•The UDT-4K HEVC UHD Multiband Transmitter is completely compatible
with the DVB-T/T2/S/S2 Standards, included in the European Standard
ETSI EN300744 (DVB-T), ETSI EN300755 (DVB-T2), ETSI EN302307
(DVB-S2) (optional) and ETSI EN300421 (DVB-S) (optional).
•It is important to note that when the transmitter is switched on, the
selected RF output connection must be connected to a suitable antenna
or charged.
•It features HEVC, H.264 and Mpeg-2 encoding for 12G, high definition
(HD) and standard definition (SD) signals with ultra-low latency. HEVC
allows the same video quality, reducing file sizes by up to 50% compared
to its predecessor, the H.264.
•The UDT-4K HEVC UHD Multiband Transmitter is available from 1 GHz
to 8 GHz, for the DVB-T2 and DVB-T. The L band output for the DVB-S2
and DVB-S is optional.
•The equipment’s maximum output power for the DVB-T2/T is 100 mW
in 2 GHz frequency band, (selectable from -5 to +20 dBm) and for the
DVB-S2 and DVB-S is from -50 to + 5 dBm.
•Special care should be taken with SDI cables, quality and length, as
these are very important, especially when 12G signals are transmitted.
•If any Audio or data channel are not used in a transmission, they should
be disabled, in order to assign that bitrate to the video and achieve a
higher quality transmitted video signal.
•Only authorized personnel should open the unit and any repair or
warranty will be invalidated if the seals are broken.
