5
01420L
DESCRIPTION
•For one-person operation
•Can be used for clutch and steering systems
as well as for the fuel line during lter replacement
•Compressed air connection: 6 - 12 bar
•Vacuum 60%
•Capacity: 1 liter
SAFETY INSTRUCTIONS
Do not touch brake paddels while bleeding the brakes.
Maintenance and cleaning after use are recommended.
Also check car manufacturers advices
APPLICATION
With this brake bleeder, one person can carry out the bleeding of the brake systems.
The bleeding is done simply, quickly and clean. The brake uid is sucked into the container,
hereby spilling is avoided.
1. Connect gun to air compressor.
2. Set the brake bleeder rubber pipe on the brake system plug, and loosen the plug.
3. Activate the handle of the brake bleeder, a partial vacuum is created in the break
bleeder container, and the uid ushes into it.
4. When the uid is free of air bubbles, which you can see through the clear hose,
tighten the bleeding plug and remove the rubber pipe.
5. Repeat procedure for each brake cylinder/calibre.
6. REMEMBER: Check uid level.
