SWELLPRO JCMATTHEW D1 User manual

SWELLPRO FISHERMAN FD1 DRONE
________________________
FOR MORE INFORMATION ON FISHERMAN FD1 DRONE PLEASE PHONE JCMATTHEW NZ ON
[phone] | [email protected] | WWW.SPLASHDRONE.CO.NZ
FD1 (Swellpro Fishing Drone) CHECKLIST BEFORE FLIGHT
PRE-FLIGHT GUIDE
þ
Remember to always turn the controller on FIRST & then the drone SECOND (when powering
on) & likewise turn the drone off FIRST (when powering down)
þ
Both the Drone & Remote Controller Batteries should be fully charged, before flight
þ
Check that the Drone & Remote Controller is in FULL WORKING CONDITION
& are FREE of Corrosion & Damage, including Checking the MOTORS are spinning freely, the
Fishing Release Mechanism is working 100% correctly & the Water resistant Membrane on
the LID is not damaged.
þ
Make sure the LID is securely Fastened down with the Thumb Screws & the LID is Facing
Forward.
þ
Check That you are set on GPS Mode “G” on the Remote Controller.
þ
Check That you are in an Open Area & AWAY from any possible Electrical OR Magnetic
Interference including Metal (ie. cars)
þ
Make sure that you always do the compass calibration before your First Flight of the Day.
þ
Make sure you have a Satellite Signal Strength of “10” before taking off
þ
Make sure your PROPELLERS are ALL Installed correctly before flying.
Compass Calibration - IMPORTANT
When does the compass need to be calibrated?
1. ALWAYS When you use the drone for the first time on a given day.
2. After maintenance.
3. The distance from the last calibration area is more than 100 m.
4. The aircraft is subject to strong magnetic interference.
5. The aircraft has been impacted or vibrated violently.

SWELLPRO FISHERMAN FD1 DRONE
________________________
FOR MORE INFORMATION ON FISHERMAN FD1 DRONE PLEASE PHONE JCMATTHEW NZ ON
[phone] | [email protected] | WWW.SPLASHDRONE.CO.NZ
6. Then hovering in GPS mode, the aircraft has wobble or large drift.
7. The remote control prompts "warning compass error calibrate compass".
How to calibrate:
Remote Control Operation
Description
1. Place the aircraft horizontally, turn on the remote
control and the aircraft in turn, and wait for the aircraft to
complete the self-test. Quickly switch the flight mode
paddle, when the green light of the rear arm flashes
quickly, or the remote control display screen prompts
"compass calibration rotate the aircraft horizontally", the
system will enter the calibration state.
2. At this time, pick up the aircraft horizontally, rotate it
clockwise for about 2-3 turns until the green light of the
rear boom flashes slowly, or the remote control screen
prompts "compass calibration rotate the aircraft
vertical", and then enter the head to rotate vertically and
downward to calibrate.
3. Turn the NOSE DOWN vertically and clockwise for
about 2 ~ 3 turns until the remote control displays
"warning aircraft initializing, please wait". Place the
aircraft horizontally and keep it still for about 30
seconds. When the prompt "warning aircraft initializing,
please wait." on the remote control display disappears,
the calibration is successful. Please restart the aircraft.
Compass calibration needs to be carried out outdoors. Do not calibrate in strong magnetic
field area, near large metal, wireless pole or mobile phone.
FULL COMPASS CALIBRATION VIDEO CAN BE FOUND ON THE JCMATTHEW NZ YOUTUBE
CHANNEL.
IMPORTANT NOTE: PLEASE DO NOT STORE YOUR BATTERIES WHEN THEY
ARE COMPLETELY DRAINED OR FULLY CHARGED. PLEASE SEE THE
BATTERY CARE VIDEO ON JCMATTHEW NZ YOUTUBE CHANNEL.