Swissvoice Eurit 4000 User manual

Brief Operating
Instructions
Attention: Operating
instructions contain safety
precautions!
Please read before putting
into operation, and store
in a safe place.
Eurit 4000
ISDN & WAP

I203247441en_ba_d0
Safety instructions
Follow these instructions to avoid physical injury:
➭Never take the telephone apart yourself.
➭Never touch electrical contacts with pointed or metallic objects.
➭Never lay the connecting leads in such a way that they might cause someone to trip
over.
Be sure to follow these instructions when installing, connecting and using the
telephone:
➭The Eurit 4000 is for voice communication via the I DN telephone network as well as
for information access on the Internet via WAP. The device must not be used for any
other purpose.
➭The telephone is intended only for normal use in dry areas of the home or office. Do
not install or use the telephone in wet areas (e.g. bathroom) or in explosion-
endangered rooms.
➭Install the telephone away from sources of heat, direct sunlight and other electrical
appliances. Operate the telephone only in the temperature range from +5 °C to +45 °C.
➭Connect the connecting leads only to the designated sockets. Do not install or use
the telephone with damaged connecting leads. If you discover damage, have it
repaired by authorized service centers.
➭Use only genuine accessories.
➭Protect the telephone from wet, excessive dust, aggressive liquids and vapors.
➭
Clean the telephone with a soft, damp cloth or antistatic cloth. Do not use a dry cloth
or cleaning or scouring agents. trong cleaning agents or solvents are not suitable.
➭The telephone may be repaired only by authorized service personnel.
➭Do not carry the telephone by the connecting leads.
➭Do not drop the telephone.
➭Place the telephone on a non-slip surface.
➭The feet of the telephone may leave marks.

II
203247441en_ba_d0
1 Display with backlighting
for menu functions, information, texts and graphics
2 inus key
Press the minus key to reduce the olume (handset and loudspeaker).
3 Plus key
Press the plus key to increase the olume (handset and loudspeaker).
4 icrophone mute key
Press the microphone mute key to
– switch the microphone on or off (handset microphone, handsfree microphone).
– withhold your own phone number when calling.
5 Loudspeaker key
Press the loudspeaker key to
– follow the connection status when dialing.
– acti ate/deacti ate listening by loudspeaker/handsfree talking during a call.
O erall iew and control panel
28
27
12345 67 89
10 11 12 13 14
15
16
171819202122232425
26

III 203247441en_ba_d0
O erall iew and control panel
6 key
Press the key to
– launch the WAP browser, establish an Internet connection and go to the WAP
home page.
– terminate the Internet connection (if the WAP browser has already been
launched) and restore the telephone to default mode.
7 Fox key
The a ailable functions are shown on the bottom line of the display and are
acti ated by pressing the Fox key directly below the corresponding text.
8 User key
Press the user key to change the user profile on the telephone.
9 LED
The LED tells you the status of your telephone.
LED off – telephone answering machine off
LED lit – telephone answering machine on
– call forwarding unconditional
– if there is a call with olume = 0 or do not disturb
LED flashing slowly – at least one message recei ed
LED flashing quickly – capacity of telephone answering machine exhausted
10 Telephone answering machine key
Press the telephone answering machine key to switch your telephone answering
machine on or off.
11 Redial key
Press the redial key to open the redial memory. The redial memory stores the phone
numbers which were last dialed (up to 1000 entries).
12 LOG key
Press the LOG key to open the LOG memory. The LOG memory stores all incoming
and outgoing calls, SMSs, UUSs, incoming oice messages for the telephone
answering machine, info messages as well as WAP addresses entered using the
keypad (1000 entries).
13 PARK key
Press the PARK key to park the existing call.
14 key
Key, freely assignable for each user, for phone numbers, e-mail addresses, WAP
addresses or functions.
15 Dial keypad
Use the dial keypad to enter numbers and the characters * and #.
16 Alphanumeric keypad
Use the alphanumeric keypad to enter letters as well as special characters such as
full stop (period), comma, brackets etc. (by simultaneously pressing the CONTROL
key and letter key).