Swytch LED Display User manual

1
LED
Display

2
00
Table of Contents
01
02
Button Diagram
Installation
Display Settings
p.3
p.4
p.5
03

3
Button Diagram
1. Button Diagram
The LED display is
controlled by one button.
Read on to learn how to
use it.

4
Installation
2. Installation
1.1 1.2To fit the LED display, simply open
up the clasp and fit around your
bikes handlebars.
Tighten the screw on the back of
the display using a 2.5mm Allen key.
!Check your brakes and gear
shifters work as normal.
1.3 Connect the green power cable into
the green cable coming out from
the mount.

5
Display Settings
3. Display Settings
Power on/off1.
Press and hold the ‘M’ button
for two seconds until the
screen turns on.
Change power level2.
3.
Short press the ‘M’ button to
change power level.
P0-P1-P2-P3-P4-P5-P0
Open settings menu
Start with the display turned off,
press and hold the ‘M’ button for
six seconds until it cycles through
the first screen and onto the next
one.
Select your top speed by short
pressing ‘M’. Double press ‘M to
confirm.
km/h
km/h
km/hmph
88
p0 p 1 p2 p3 p4p
5
Lvl 0 Lvl 1 Lvl 2 Lvl 3 Lvl 4 Lvl 5
M
M
M
Press and hold - 6 sec
Long press - 2 sec
Short press

6
Display Settings
Unit
Swap between metric and imperial
units by short pressing ‘M’. Double
press ‘M’ to confirm selection and
move onto the next setting.
Settings Menu
Wheel size
Set your wheel size before you ride your
kit for the first time. Useful if you’re
swapping your kit between bikes. Change
between different wheel sizes by short
pressing ‘M’. Double press ‘M’ to confirm.
Top speed
Select your top speed by
short pressing ‘M’. Double
press ‘M to confirm.
To exit settings at any time, press and hold the ‘M’ button until the display turns off.
km/hmph
00
25
!25KM/H is the legal limit for UK
and Europe.
M
M
M
M
M
M
x2
x2
x2
Confirm
Confirm
Confirm
Change option
Change option
Change option

7