SYNERGEE SF 2200-WF User manual

IF ANY PIECES ARE MISSING, PLEASE CONTACT US IMMEDIATELY: [email protected] OR 1.855.217.7136
KEY PART QTY BOX KEY PART QTY BOX
1. TOP UPRIGHT 2 1 11. EXPANSION SCREWS M10X80 SET 8 3
2. BOTTOM UPRIGHT 2 1 12. SELF TAPPING SCREW M10X80 8 3
3. M10X20 BOLTS (FULLY THREADED) 4 1 13. M10 WASHER 8 3
4. M10 WASHERS (FOR UPRIGHTS) 4 1 14. M16X75 BOLTS (PARTIALLY THREADED) 8 3
5. PULL UP BAR 1 2 15. M16X100 BOLTS (PARTIALLY THREADED) 4 3
6. J CUP 2 2 16. M16 WASHER 36 3
7. M16X80 BOLTS (PARTIALLY THREADED) 2 2 17. M16 NUT 14 3
8. WALL MOUNTS 4 2 18. SAFETY PIN (FOR PULL UP BAR) 2 3
9. SAFETY PIN 4 2
10. MOUNTING ARMS 4 3
P
A
R
T
S
SF 2200-WF
STEP 1 STEP 3
STEP 2
1
9
REPEAT STEPS FOR BOTH UPRIGHTS BEFORE MOVING ON
REPEAT STEPS FOR BOTH
UPRIGHTS BEFORE MOVING ON
Assemble the rack wall mount frame to the
uprights as illustrated below.
Slide the top upright into
the bottom upright
aligning the two half
circles.
The top upright will be
indicated by the arrow at
the top.
Slide the bolt through the back most hole
on the upright using 4 washers as
illustrated. Repeat step for all 4 rack
frame mounts (9).
Insert bolt into the uprights. Fasten into
the built in fastener in the rack uprights.

STEP 2
STEP 2
Once assembled with the pull-up bar hold the rack against the wall and you may begin to install the rack to your wall
at your own discretion.
Use the folding rack mounting (8) to. Attach to the wall using parts (10 or parts 11 and 12). To secure to the oor use the
expansion screw set (16).
When using at all times ensure the safety pins are inserted into the rack frame wall mount (18) as shown above. If the
pins are not inserting please try and ensure the arms/wall mount frame are straight. arms are straight.
Do not try and use the machine while no pins are inserted.
IMPORTANT: When holding against the wall to nd an install location, ensure the bottom of the rack is touching the
ground. If not on the ground the rack may not fold properly
TO FOLD REMOVE PINS, PULL-UP BAR AND J CUPS. LIFT THE UPRIGHT FROM THE BASE AND SWING IT
IN THE DIRECTION YOU WANT TO FOLD IN. FOLDING GUIDES ARE AS DISPLAYED ABOVE.
18
18
18