SYSMEX XW-100 User manual

XW™-100 AUTOMATED HEMATOLOGY ANALYZER
CLIA WAIVED
START-UP QUICK GUIDE
BEYOND A BETTER BOX™
Code No. AD794857 en-am
PRINTED IN JAPAN
Date of Issue: 11/2017
Document Version: 2.0
Software Version: Ver.1© SYSMEX CORPORATION 2017

2
X W-100 S TA RT-UP
3. Remove the XW-100 and Power Cord from Box 2.
4. Connect the Power Cord to the XW-100 by inserting it into the socket
in the back.
5. Insert the Power Cord into a 3-prong outlet.
(Continued on next page)
SAFETY WARNINGS:
• The XW-100 weighs approximately 38 lbs.; DO NOT try to lift it
without help.
• Install the instrument with the following clearance, for ventilation:
• At least 6 inches at the front and sides.
• At least 12 inches at the back.
• DO NOT place anything on, bend, kink, or pull the Power Cord.
• Improper grounding of the instrument can cause electrical shock.
• The printer head can get very hot. DO NOT touch! Only use
paper recommended by Sysmex.
Start-up
1. Choose a convenient work space:
• Near an internet connection (provided Ethernet cable is 6.6 feet long) and a 3-prong power outlet
(provided power cord is 6.6 feet long).
• Ensure the space is level, dry, dust-free, and protected from splashing water.
• Avoid installation within 1 foot of devices that may cause potential interference, such as radios, computers,
and wireless devices.
• Environmental conditions:
• Ambient temperature: 15 - 25 oC or 59 - 77 oF
• Relative humidity: 30% - 85%
2. Unpack the XW-100. Ensure that the Start-up Quick Guide is present and perform a parts check on the boxes
that arrive with the analyzer:
Box 1: (open rst)
• Reagent Tray
• Thermal Paper
• Waste Bottle
• Adapters (Green and White)
• Clinician's Quick Guide
• Operator's Quick Guide
• Shutdown Quick Guide
• Technical Specications
Box 2:
• Power Cord
• Ethernet Cable
• Barcode Reader and Cable
• Reagent Tubing
• COIL TUBE SS-10
• Instructions for Use

3
X W-100 S TA RT-UP
7. Switch the Power button to the "I" position (as opposed to
the "O" position), to turn on the XW-100.
8. Follow the instructions on the
screen to complete the setup; when
requested, insert the Ethernet Cable
plug into the network socket.
9. During Initial Setup, the system will instruct the user to scan the
barcode on the Quick Reference Guide. Use the barcode below to
do so. If the Barcode Reader is working properly, the screen will
react.
664369 10197 8
Start-up, continued from previous page
6. Insert the plug end of the Barcode
Reader cord into the "BR" plug on the
side of the XW-100.

Program availability varies by location. Programs and specification subject to change without notice.
Sysmex America, Inc.
577 Aptakisic Road
Lincolnshire, IL 60069, U.S.A.
Tel. [phone]
www.sysmex.com/us
Sysmex Corporation
1-5-1 Wakinohama-Kaigandori
Chuo-ku, Kobe 651-0073, Japan