TaoTronics TT-TF011 User manual

尺寸：210*140mm
骑马钉
封面128g铜版纸，内页80g书纸
双色印刷

TAOTRONICS
WALL FAN
User Manual
Questions or Concerns?
[e-mail]
N
O
R
MA
L
SLEEP
BREEZE
H
I
G
H
MED
-
LO
W
M
E
D
-
H
I
GH
LO
W
M
ED
2
1
8
4

Contents
IMPORTANT SAFETY INSTRUCTIONS 01
ASSEMBLING YOUR FAN 04
USING YOUR FAN 09
CLEANING AND MAINTENANCE 14
TROUBLESHOOTING 16
WARRANTY AND SERVICE 18

01 02Wall Fan Wall Fan
IMPORTANT SAFETY
INSTRUCTIONS
BEFORE USING THIS APPLIANCE READ
ALL INSTRUCTIONS AND CAUTIONARY
MARKINGS IN YOUR USER MANUAL AND ON
THE APPLIANCE.
DO NOT touch or hold the mains
plug with wet hands.
DO NOT block or cover air flow to
or from the fan while in operation.
DO NOT insert fingers or objects
through the grille while in operation.
INTENDED USE
• This appliance is not intended for use by people (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
the use of the appliance by person responsible for their safety.
• Close supervision is necessary when any appliance is used by or near
children. Children should be supervised to ensure that they do not play with
the appliance. Cleaning and user maintenance shall not be done by children
unless they are older than 8 and supervised.
• Use the appliance only for intended household purposes as described in this
User Manual. Any other use is not recommended that may cause fire, electric
shock, or injury to people.
ELECTRICITY SAFETY
• This appliance must be provided with correct voltage via a professionally
installed power socket. Make sure the voltage indicated on the label of the
appliance is the same as your local supply.
• IMPORTANT - This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician. Do not attempt to
rig this safety feature.
• This product employs overload protection (fuse). A blown fuse indicates
an overload or short-circuit situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user servicing instructions
(follow product marking for proper fuse rating) and check the product. If the
replacement fuse blows, a short-circuit may be present and the product should
be discarded or returned to an authorized service facility for examination and/
or repair.
Summon A Cool
Breeze Into Your
Space
01

03 04Wall Fan Wall Fan
• WARNING: To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan
With Any Solid-State Speed Control Device.
• Include instructions pertaining to a risk of fire, electric shock, or injury to
persons, for cleaning and user-maintenance, such as lubrication.
• DO NOT operate any fan with a damaged cord or plug. Discard fan or return to
an authorized service facility for examination and/or repair.
• DO NOT run cord under carpeting. Do not cover cord with throw rugs, runners,
or similar coverings.
• DO NOT route cord under furniture or appliances. Arrange cord away from
traffic area and where it will not be tripped over.
• Disconnect the appliance from the power supply before servicing.
FOR HOUSEHOLD USE ONLY
READ AND SAVE
THESE INSTRUCTIONS
Have your wall fan checked regularly
for any sign of malfunction!
Check if
• Plug, cord or appliance is damaged.
• Excessive noise, unpleasant odor or
abnormal heat.
Stop using, check FAQ and contact
TaoTronics Support Team.
Regular Check
ASSEMBLING YOUR FAN
Summon A Cool
Breeze Into Your
Space
02
Specifications
Model
Input
Rated power
TT-TF011
120V~ 60Hz
55W

05 06Wall Fan Wall Fan
Rear GrilleRear Grille NutBlade Cap BladeFront Grille Fan Head Screws Wall Bracket Screw Anchors
Assemble Your Fan
Unscrew the rear grille nut counterclockwise.
2
Insert the blade through the
shaft and secure the blade
with the blade cap.
(Note: Make sure the
retaining pin on shaft fits
into the groove on blade.)
1. 2. 1Position the rear grille onto the fan
head and turn the grille nut clockwise
to secure the rear grille.
(Note: The three alignment holes must
be aligned with the three prongs.)
2
1
Remote Control
N
O
R
M
A
L
S
LEE
P
BREEZE
2
1
8
4
H
I
GH
M
E
D
-
LOW
M
E
D
-
H
I
GH
L
O
W
M
E
D
N
O
R
MA
L
SLEE
P
B
R
EEZE
2
1
8
4
H
I
GH
M
E
D
-
LO
W
M
E
D
-
H
I
GH
L
O
W
M
E
D
Groove

07 08Wall Fan Wall Fan
Assemble Your Fan Mount Your Fan
1Open up all locking clips.
3
Put all clips back to clamp tightly.
3. 4.
1Measure the distance between
two holes in wall bracket, drill two
identical holes in wall with a proper
drill bit as the illustration shows.
X
Y
Length X＝Y
2
Push the screw anchors separately
into the holes, then fix the wall
bracket in position with the screws.
3
Slide metal sheet into the wall bracket
to hold the fan in place.
2
Align front and rear grilles, then
snap the front grille into place as
the illustration shows.
2
1
NOR
M
A
L
S
L
EEP
B
R
EEZE
H
I
G
H
M
ED
-
LO
W
M
E
D
-
H
I
GH
LO
W
M
E
D
2
1
8
4
N
O
R
M
A
L
S
L
EE
P
BR
EE
Z
E
H
I
GH
M
E
D
-
LO
W
M
E
D
-
H
I
G
H
LO
W
M
E
D
2
1
8
4
NORMAL
SLEEP
BREEZE
HIGH
MED-
LOW
MED-
HIGH
LOW
MED
2
1
8
4
3
2

09 10Wall Fan Wall Fan
Control Panel
Power ON/Standby
Turn on /Standby mode.
Fan Mode
Press repeatedly to cycle through
NORMAL, SLEEP, BREEZE.
Fan Speed
Press repeatedly to cycle through LOW,
MED-LOW, MED, MED-HIGH, HIGH.
Timer
• Press to set timer for turning on /
off the fan (1H-2H-4H-8H).
• Long press to cancel timer.
Oscillation
Press to start / stop oscillating.
NORMAL
SLEEP BREEZE
MED-
LOW
MED-
HIGH
LOW
MED
HIGH
2
18
4
USING YOUR FAN
Summon A Cool
Breeze Into Your
Space
03

11 12Wall Fan Wall Fan
• NORMAL: LOW, MED-LOW, MED, MED-HIGH, HIGH.
• SLEEP : LOW, MED, HIGH.
• BREEZE : LOW, MED, HIGH.
NORMAL
SLEEP
BREEZE
HIGH
MED-
LOW
MED-
HIGH
LOW
MED
2
1
8
4
Remote Control Fan Modes Additional Features
User Servicing Instructions
Note: For added convenience, the same control buttons can be
found on the remote control.
This wall fan features a fused safety plug which is designed to cut
off electric current to the fan if an electrical fault occurs. If your fan
loses power and you suspect that the fuse on your fan has blown,
Power ON/Standby
Fan Speed -
Oscillation
Timer
Fan Mode
Fan Speed +
LED ON/OFF
Normal mode Running with selected constant speed.
Sleep Mode Fan speed drops one level every 30 minutes until
the lowest then stays.
Breeze mode Fan speed cyclically changed for mimic natural wind.
Memory Function:
The fan is designed with power off memory function.
It will always remember your last settings (except
timer setting) once you turn it on again.
2
1
3
4
1Grasp plug and remove from the receptacle or other outlet device. DO NOT
unplug by pulling on cord.
2
Open fuse cover. Slide open fuse access cover on top of attachment plug
towards blades.
3
Remove fuse carefully. Insert the tip of your tool into fuse slot (close with
the terminal), then prize the fuse gradually and slowly, but not overexert. If
you feel tight, you can try it at several times and prize the fuse little by little.
When one side of the fuse has been prized, then you can get the fuse out
entirely. Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse.
4
Close fuse cover. Slide closed the fuse access cover on top of attachment
plug. Risk of fire. DO NOT replace attachment plug. Contains a safety device
(fuse) that should not be removed. Discard product if the attachment plug
is damaged.

13 14Wall Fan Wall Fan
Replacement of Battery
• Replace with new batteries of the same type when replacement
is required.
• When not using the remote control for a long time, please take
out the batteries.
• Do not attempt to dismantle the batteries.
• Do not dispose the batteries in fire, batteries may explode or leak.
• Do not use rechargeable batteries.
1Press the locking button to remove the battery holder.
2
Replace the battery with the same type (CR2025, 3V), making sure the (+) side
facing up.
3
Push in the holder until securely locked into place.
2
1
3
WARNING:
Do not ingest battery, Chemical Burn Hazard.
This product contains a coin / button cell battery. If the coin / button cell
battery is swallowed, it can cause severe internal burns in just 2 hours
and can lead to death. Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the
product and keep it away from children. If you think batteries might have
been swallowed or placed inside any part of the body, seek immediate
medical attention.
The batteries contain materials, which are hazardous to the environment;
they must be removed from the appliance before it is scrapped and that
they are disposed of safely. CLEANING AND MAINTENANCE
Summon A Cool
Breeze Into Your
Space
04

15 16Wall Fan Wall Fan
A soft cloth is recommended for cleaning the blade.
To remove dust between the grilles, a pipe cleaner,
flexible dust wand, vacuum cleaner or compressed air
are acceptable.
• Always make sure the wall fan is turned off and unplugged
before cleaning.
• DO NOT stick any foreign objects or your fingers inside
of the unit.
• Never immerse in water or allow water to drip into the
motor housing.
• DO NOT clean with abrasive chemicals or flammable
cleaning agents.
Always take the fan off wall before cleaning
for safety reasons.
TROUBLESHOOTING
Summon A Cool
Breeze Into Your
Space
05
N
O
R
MA
L
SLEEP
B
R
EEZE
H
I
GH
MED
-
L
O
W
M
ED
-
H
I
GH
LOW
M
E
D
2
1
8
4

17 18Wall Fan Wall Fan
The troubleshooting guide addresses the most common
problems. If problems persist, feel free to contact our
Customer Support at
[email protected]
WARRANTY AND SERVICE
Thanks for choosing TaoTronics wall fan. This product is covered with TaoTronics product and labor warranty for 12
months from the date of its original purchase.
The warranty will not apply in cases of:
• Accident, misuse, or repairs performed by unauthorized personnel.
• Any unit that has been tampered with or used for commercial purpose.
• Normal wear and tear of wearable parts.
• Use of force, damage caused by external influences.
• Damage caused by non-observance of the User Manual, e.g. connection to an unsuitable mains supply or non-
compliance with the instructions.
• Partially or completely dismantled appliances.
• Defects caused by or resulting from damages from shipping or from repairs, service, or alteration to the product or
any of its parts that have been performed by a repair person not authorized by TaoTronics.
We can only provide after sales service for products that are sold by TaoTronics or TaoTronics authorized retailers and
distributors. If you have purchased your unit from a different place, please contact your seller for return and warranty
issues.
* Please have your invoice and order ID ready before contacting Customer Support.
Q
Excessive noise.
Fan does not operate.
Oscillation is not
steady or fan vibrates.
Why the remote
control is not working.
A
• It is normal that there is noise during operation. If too loud, please set the fan to lower speed.
• Check if the blade is installed properly.
• Make sure the fan is connected to a powered electrical outlet.
• Make sure the fan is mounted firmly on a vertical wall.
• Clean the blade regularly.
• Make sure the fan is connected to a powered electrical outlet.
• Check that the remote control is powered and move the obstacles between the fan and the
remote control.
• Operate the remote control near or in front of the wall fan.
N
O
R
M
A
L
S
L
EE
P
BR
EE
Z
E
H
I
GH
M
E
D
-
LO
W
M
E
D
-
H
I
G
H
LO
W
M
E
D
2
1
8
4

[email protected]
www.taotronics.com
Manufacturer: Shenzhen NearbyExpress Technology Development Co.,Ltd.
Address: Floor 7, Building E, Galaxy World Phase II, Shenzhen, China
Rev_1.3_EN
Model:TT-TF011
Made in China
Intertek
5018396
CM