Tapepro CORNER BOX User manual

TAPEPRO CORNER BOX

TAPEPRO CORNER BOX
The Tapepro Corner Box is designed to be used with the Tapepro Corner Finisher or Corner
Glazer to apply a finishing coat to all 90º internal angles. This is one of the last procedures
and will cover the tape with joint compound and feathering the compound onto the
plasterboard.
BEFORE USE
USING THE TAPEPRO CORNER BOX
> Ensure that the Tapepro Corner Box is free from any dry joint compound.
(CB-1)
> Check that both the pressure plate and the filler valve move freely.
1. Fill the Tapepro Corner Box by removing the nozzle from the box
filler which is attached to the loading pump. Insert the Tapepro
Corner Box filler valve into the box filler. (CB-2)
2. Pump until the box is full.
3. Snap the Tapepro Corner Finisher or Corner Glazer onto the nose
cone of the Tapepro Corner Box. When using a Corner Finisher,
ensure the swivel chain is attached, to reduce the risk of damage.
(CB-3)
4. Place the Tapepro Corner Finisher or Corner Glazer at the top
of the internal. Apply pressure and pull the Tapepro Corner Box
down the internal to approximately 600mm from the bottom of
the joint. (CB-4 & CB-5)
5. Turn the Tapepro Corner Box around and starting from the
bottom of the joint run up the internal. (CB-6)
CB-1
CB-2
CB-3

All manufacturing faults are covered under the Tapepro warranty.
All non wear parts are covered under a 3 year warranty.
CLEANING
MAINTENANCE
WARRANTY
Your Tapepro Corner Box should be cleaned after every use to maximise
lifespan and maintain optimal performance.
1. Fully open the Tapepro Corner Box by loosening the thumb
screws on the side of the box and thoroughly clean with a hose
and stiff brush.
2. Ensure all joint compound is removed from the box and nose
cone.
All replacement parts are available from your local plasterboard
distributor or Tapepro Drywall Tools. For your nearest distributor please
visit our website: www.tapepro.com or call Tapepro Drywall Tools on
[phone].
CB-4
CB-5
CB-6
CB-7

For further information contact: TAPEPRO DRYWALL TOOLS
Phone: [phone] | Fax: [phone] | Email: [email protected] | Website: www.tapepro.com
CBA001A
CBA005A
CB024
AT062
AT041
AT120
CB024
CBA009
CB008
AT100
AT121
CBA009
CBA010
CB021
AT062
CB014
S012 3"
CB020
CB019
F008
F008
SA051
CB018
CB023
CR015A
CR016
CR016
Same as HE-1200
HE002