Technicolor TG582n User manual

1
Installation Guide - Fibre Wireless Modem - Technicolor TG582n
Getting Your Internet Running
Check your modem package contents. It should contain the items shown here:
Front Panel LED Explanation
Connect Your Modem

2
Refer to your modem user guide or follow the below steps:
1. Install DSL filters on all telephony devices in your home. (This includes phones, fax machines, satellite
receivers and security systems.)
2. Connect the power supply to the Technicolor modem and plug it in.
3. Connect the phone cord to the Technicolor modem and plug into the phone wall jack. (There should be no
surge suppressors or DSL filters on this line.)
4. Connect the network cable to the Technicolor modem and then into the Ethernet port on your computer.
5. Turn the power on and wait for approximately one minute.
6. The DSL/ADSL/SYNC light should now be solid on.
7. Contact us if you have any question.
Setup Internet Connection
Before Setup your modem, please reset your modem first.
1. Open a web browser, on the Address Bar Type:
192.168.1.254
2. Login Page - Username:admin & Password:1234 (Please ignore it if first time)

3
3. Then, You can see then main page of Technicolor TG852n.
Click Technicolor Gateway on left side menu.
4. Click Setup my Technicolor Gateway

4
Setup your internet setting for Technicolor Modem - TG582n
Step 1: Click Setup my Technicolor Gateway
Step 2

5
Step 3: Select 0.35 on VPI/VCI drop down list

6
Step 4: Input your Internet World-Link User Name & Password ( for login internet use )
Step 5: Modem Password ( for modem use ) usually user: admin & password: 1234

7
Step 6: Click Start button
Step 7

8
Step 8
Congratulations! Your connection is up and running and you should be able to browse the internet.

9
To "modify" Internet Setup - TG582n
Step 1: Click Internet > View more...
Step 2: type your internet login Username & Password

10
Setup Wireless Network
Home Network Menu
Click Home Network on Left Menu. Then, Click Wireless Name (WLAN) on the right hand side.
(eg.WLAN:TNCAP93E9A5)
You are in "Wirelss Access Point Page" (Wireless Page). Then, Click Configure.

11
Step 1
Step 2: Wireless Key - Select WPA-PSK + WPA2-PSK
(Wireless Key default on the modem label)

12
Step 3: Show up Encryption Key(Wireless password key). Click Apply button.
After all, your wireless device can connect your modem with wireless key to the internet.