Technicolor 7200.20 DOCCSIS 3 User manual

How to set up Wireless on Technicolor 7200.20 DOCCSIS 3 Modem
1. Open a Browser and type http://192.168.0.1 in the address bar, leave the
user empty and type “admin” as the password then click OK
Note: You might have a problem when using IE, try using another browser.

2. Click Wireless > at Radio check following parameters:
2.1 Interface -> Enable or Disable Wireless

3. Primary Network for setting Wireless SSID Security, check following:
3.1 Network Name (SSID) > Wireless signal
3.2 How to set up Wireless parameters as shown

WEP
1. Primary Network select Disable WPA-PSK and WPA2-PSK
2. WEP Encryption > select Security WEP (64-bit) or WEP (128-bit)
3. Network Key > set the pass code to use Wireless
4. When finish click Apply to save setting

WPA-PSK, WPA2-PSK
1. For Primary Network, select Disable at WEP Encription
2. To use only WPA-PSK, select Disable at WPA2-PSK
3. To use only WPA2-PSK, select Disable at WPA-PSK
4. To use both WPA-PSK and WPA2-PSK, select Enable both. By Default
both parameters are Enable
5. WPA Pre-Shared Key > set the pass code to use Wireless
6. When finish click Apply to save setting