TechniSat TechniStar S2 Installation and user guide

Please aim the remote control
toward the decoder and operate slowly.
If the decoder fails to respond properly,
we suggest replacing the existing set
of batteries with new ones.
How to re-tune to the new frequency of JSTV HD
TechniSat TECHNISTAR S2
Our frequency has been updated.
If you have a TechniSatTECHNISTAR S2, please follow the instructionsbelow to add JSTV HD channels to your decoder.
Number Keys
OK
Blue
矢印ボタ
＜＜Buttons you need＞＞
Arrow
MENU
Yellow
Green
If your decoder is currently connected to the TV with a SCART cable, connecting with a HDMI cable will allow you to watch JSTV with a higher resolution.
Please note that changing cables means you need to choose a different TV input channel such as HDMI 1.

How to remove the old channels
(This procedure will take approximately 5 minutes)
2
3
1
Whenthe TV list organizer menu screen appears, make sure the cursor is on the right side of the screen.
If the cursor is on the left side, press the green button and move the cursor to the TV list on the right.
Press the Menu button on your remote control to show the Main menu on your screen.
Using the arrow button, select TV list organizer(fourth item on the list) and press the OK button.
4Move the cursor to JSTV 1 and press the blue button on your remote control. A small window will
appear on the screen.
5Select Remove by using the arrow buttons on your remote control and press the OK button.
Then press the yellow button, and the channel JSTV1 will be removed.)

Please repeat step “4” and “5” to remove JSTV2.
Now, the old channels are removed and new channels are set as channel 1 and 2
6
Press the Menu button on your remote control to save your settings and close the menu screen.
It’s all done!