Tekmar TARGET TG-200 User manual

TG-200
INSTRUCTIONS AND CARE
Congratulations, you have just purchased one of the finest spot cleaning guns available today. It
is manufactured to TEKMAR’s high quality standards from the best available materials and
parts. When used as directed it should provide years of trouble free service.
For safe operation it is important to understand that this is not a toy. It is a high powered airless
spray gun which has the potential, when not used as directed, to cause a serious puncture wound.
SAFE OPERATING INSTRUCTIONS
Never point the gun at any part of your body or at any other person.
Always check electric cord for damage before using. If damaged do not attempt any temporary
repairs.
Only use with adequate ventilation and always wear eye protection.
Use only approved cleaning solvents. Never spray flammable solutions into the air.
INSTRUCTION FOR USE
1. Fill fluid bottle 4/5 full and replace on gun. Squeeze trigger until gun primes and fluid comes
out of the nozzle.
2. Place garment to be cleaned on a clean absorbent cloth or exhaust surface. Direct a jet of
cleaning solvent through stain in a circular motion, until soil is flushed through.
3. To avoid ringing adjust nozzle to wide spray pattern and spray around wet edge to feather out
giving a smooth transition from wet to dry.
4. Always test fabric in an inconspicuous area to ensure color fastness.
CARE OF GUN
Weekly (or daily for high use) apply 2 or 3 drops of a light lubricating oil to the oil hole on top
of the gun behind the pump.
Never use with a corrosive or water based cleaner (this will also void warranty).
Periodically (or if the gun is to be stored for any period of time) drain it of any cleaning fluid and
run a light machine oil (3 in 1 type) for a few seconds.
For more information please contact
TECHNICAL MARKETING LTD.
P.O. BOX 4700
SANTA BARBARA, CA. 93140
TEL [phone] FAX [phone]
CUSTOMER LINE [phone]

TG-200
Position Part # Description Position Part # Description
1. 200-01 GUN HOUSING 13. 200-13 PUMP CYLINDER
2. 200-02 HANDLE SET 14. 200-14 PISTON
3. 200-03 COIL MOTOR 15. 200-15 PISTON SPRING
3. 200-03-220 220V COIL MOTOR 16. 200-16 PUMP ROD
4. 200-04 SWITCH 17/18/19 200-17 VALVE
5. 200-05 ARMATURE 20. TG1 NOZZLE
5B. 200-05B ARMATURE SPRING 21. 200-21 CONTAINER
6. 200-06 ELECTRIC CORD 22. 200-22 SUCTION TUBE
7. 200-07 BUFFER 23. 200-23 PUMP SCREW
8. 200-08 VOLUME CONTROL 24. 200-24 TERMINAL BLOCK
9. 200-09 VOLUME SPRING 25. 200-25 RUBBER GUIDE
10. 200-10 PUMP HOUSING
11. 200-11 ADJUSTING ROLLER
12. 200-12 ROLLER SPRING
When ordering parts, to avoid incorrect items being shipped always have the gun model # and
part #’s available.