Tektronix Phaser 140 User manual

Co
py
ri
g
ht © 1994 b
y
Tektronix, Inc. All ri
g
hts reserved. 063-2260-01
Instruction Sheet
Installation tips
Please read over these tips before installing your Phaser 140 Color Printer.
Installing the print head
The print head is packaged in a sealed plastic box ( 1 ). When unpacked, the print
head appears as shown (
2 ).
Before installing the print head, be sure to remove the packing material.
For more information on installing the print head, see ÒInstalling the print
head,Ó in Chapter 2 of the user manual.
1
2
4686-7-1
4868-7-3
Phaserª 140

2
Installation tips
Installing ink cartridges
When installing ink cartridges, be sure to press down on the cartridge until it
snaps into place.
For more information on installing ink cartridges, see ÒInstalling ink cartridges,Ó
in Chapter 2 of the user manual.
First-time power-up
When you turn on the printer for the Þrst time , the printer purges the ink jets.
This Þrst-time printhead initialization takes a few minutes. When the Þrst-time
power-up is complete, the printerÕs front panel displays
ready and the two
green lights on the front panel are lit.
When the Þrst-time power-up is complete, the printerÕs front panel may display
ink out instead of ready . If this happens, press the SELECT button. The
printer purges the ink jets again before displaying
ready . In rare cases, the front
panel will display something other than
ready after the second purge. If this
happens, turn the printer off, then on again. The printer will power-up correctly
the second time.
The printer is shipped with the startup page enabled. However, when you turn
on the printer
for the Þrst time , or when you install a new print head, you may not
get a startup page. The printer will print a startup page on all subsequent
power-ups, until the startup page is disabled.
For more information on the printerÕs power-up sequence and the startup page,
see ÒConnecting the power and turning on the printer,Ó in Chapter 2 of the user
manual.
4868-7-2
SELECT