COMMITTED
TO
EXCELLENCE
Instructions
P6455
TTL/MOS
PATTERN GENERATOR
PROBE
Digital Analysis System 9100 Series
3616-01
P6455 TTL/MOS Pattern Generator Probe with leads and hook tips.
OPERATOR'S INFORMATION
NOTE
This
sheet is intended as an introduction only. For
complete operator's information, refer to
the
DAS
9100 Series Operator's Manual.
INTRODUCTION
The P6455 TTLJMOS Pattern Generator Probe is designed
for
use
with
the
91
P16 Pattern Generator module or the
91
P32 Pattern Generator Expander module
of
the DAS
9100 Series.
The P6455 supplies TTL or MOS stimulus outputs at pulse
rates up to
25
MHz. Outputs consist of eight data channels,
a clock
line
,
and
a strobe line. Three different lead sets
are
available for use with the P6455. For information concerning
proper selection
and
use of lead sets, refer to the DAS 9100
Series Operator's Manual.
A black VL (voltage low) sense lead
and
a green
VH
(voltage
high) sense lead
are
provided
as
standard equipment.
Output levels will swing between the low and high voltages
to which these two leads are connected.
The P6455
can
occupy any available pod connector at the
rear of a 91P16 or
91
P32
module. To display the bus slot
locations of modules installed
in
your DAS, press the STOP
key
on
the DAS keyboard while holding the SHIFT key
down. To make sure the probe is positioned correctly, press
the
red
button located next to the cable outlet at the base of
the probe. The probe's pod assignment (module and
connector number) will appear at the upper left of the DAS
screen.
For proper operation, the NORM-AUX switch located on the
back side of the probe must
be
set to NORM. For complete
details, refer to the
DAS
9100 Series Operator's Manual.
To
avoid damaging
the
P6455 when removing it from
a module, always grasp
the
probe
by
the connector
housing, never by
the
cable.
070-3616-00
Product Group
57
Copyright
@'
1981
, 1985, Tektronix, Inc. FIRST PRINTING JUNE
1981
REVISED PRINTING AUGUST 1985
All rights reserved.
