Tennant V10 Product manual

9001233
Rev. 00 (11-04)
Operator and Spare Parts Manual GB
Model No.:
MV102044
MV102944
TENNANT N.V.
Industrielaan 6 5405 AB P.O. Box 6 5400 AA Uden-The Netherlands
[email protected] www.tennantco.com
V10
ATTENTION: READ CAREFULLY THE PRESENT HANDBOOK OF
INSTRUCTIONS BEFORE STARTING UP THE VACUUM CLEANER.
KEEP THIS MANUAL OF INSTRUCTIONS ALWAYS IN EVIDENCE FOR A
RAPID CONSULTATION. SAVE CAREFULLY THE PRESENT HANDBOOK.

Tennant V10
3
N.B. Drawings above reported
are merely indicative.
DESCRIPTION AND ASSEMBLY
A - Motor block.
B - Switch.
C - Float: its purpose is to avoid that
liquid may goes inside motor block
during suction.
D - Polyester filter to set into the tank
to pick up dust, and to remove for
liquid suction.
E - Hooks for tightening of motor block
to tank.
F - Suction inlet.
G - Tank.
H - Flexible hose.
I - Tube.
L - Wet tool.
M - Round brush.
N - Flat lance.
O - Paper bag (on request) to fit directly
on the suction inlet. Its use does not
exclude the employ of polyester filter
that has to be aniway used.
P - Small brush.
Q - Aspirmatic double use brush.
R - Wand.
ATTENTION
In order to keep in good efficiency the
machine it is useful to clean the polyester
filter after each utilization.
Q
I
H
I
R
O
C
D
E
F
G
OPTIONAL
A
B
PNML

Tennant V10
4
4
2
DRY CLEANING
OPERATING INSTRUCTION
- Insert the cloth filter in the tank (Fig. 1).
- Assembly the head on tank and block it by
hooks (Fig. 3).
- Connect the flexible hose into the inlet
(Fig. 4).
- Connect the wand and the extensions to
other side of flexible hose (Fig. 5).
- Select the most suitable accessory
(Fig. 6).
- Connect the plug to power socket then
switch on the equipment (Fig. 7).
- Example of use of flat lance (Fig. 8).
- Example of use of small tool (Fig. 9).
- Example of use of brush on the floor
(Fig. 11).
- Example of use of brush on the carpet
(Fig. 12).
- Example of use of round brush (Fig. 10).
- If a paper bag is provided, insert it in the
tank on the deflector (Fig. 14).
LIQUID SUCTION
OPERATING INSTRUCTION
- Remove the cloth filter bag (Fig. 2).
- Assembly the head on tank and block it by
hooks (Fig. 3).
- Connect the flexible hose to the inlet
(Fig. 4).
- Connect the extension to other side of
flexible hose (Fig. 5)
- Connect the wet tool (Fig. 6).
- Connect the plug to power socket then
switch on the equipment (Fig.7)
- Example of use of wet tool (Fig. 13).
3
7
5
6910
1
11
8
14
12 13

Tennant V10
5
INSTRUCTIONS TO BE STRICTLY FOLLOWED
• Components used in packaging (Ie. plastic bags)
can be dangerous: keep away from children and
animals.
• The use of this machine for anything no specified
in this manual may be dangerous and must be
avoided.
• The suction nozzle should be kept away from the
body, especially delicate areas such as the eyes,
ears and mouth.
• The equipment should be correctly assembled
before use.
• Ensure that power socket used is correct for the
machine.
• Check the voltage indicated on the rating plate is
the same as the supply voltage.
• ATTENTION: these machines are not designed for
picking up health endangering dusts or
infiammable/esplosive substances.
• Never leave the equipment unattended whilst in
use.
• Never carry out any maintenance on the machine
without first disconnecting from the mains supply,
if the machine is to be left unattended the supply
should also be terminated.
• The main supply cable should not be used to pull
or lift the machine.
• The machine should never be emersed in water
or a pressure jet of water used for cleaning.
• Should the line cable be damaged, this must be
either replaced by the manufacturer or by its service
centre or in any case by a person having similar
skills, so as to prevent any risk.
• Should extension cables be used, ensure that the
Technical data
Description
Voltage V 220-240
Frequency Hz 50/60
Rated Power W 1000
Depression mbar 2200
Air Flow l/s 47
Height mm 600
Length mm 400
Width mm 380
Dust Capacity of Bag l/s 25.2
Sound level dB(A)171
Mass (without accessories) kg 7.4
1) EN 60704-1 (1996)
EN 60704-2-1 (2000)
ISO 3744 (1994)
cable rating is suitable for use with equipment. Do
not use the cable coiled as this could result in a
voltage drop or overheating. Keep dry at all times.
• ATTENTION: turn off immediately in case of foam
or liquid substance leakage.
• Ensure that the float (C) is not damaged or
obstructed by anything that may stop it from rising.
the floats
function is to stop the suction when the tank is full
or if the machine should overturn accidentally.
• If the equipment should overturn it is recommended
that the machine should be stood up before
switching off.
• This equipment should not be used to pick up
water from containers, lavoratories, tubs, etc.
• Aggressive solvents or detergents should not be
used.
• Service and repairs must be carried out by qualified
personnel only. Replacement parts for the machine
must be manufacturers original spare parts only.
• The manufacturer cannot be held responsible for
any damage/injury caused to persons or property,
because of the incorrect use of the machine due
to procedures being used which are not specified
in this instruction manual.
NOISE LEVEL
Values measured according to EN 60704 - 1 (1996) /
EN 60704 -2 - 1 (2000) rules.Measurement A for the
sound pressure level of the machine is 71 dB (A)
Under unfavourable feed conditions, the appliance may
cause temporary drops in voltage.