Tethon 3D Bison 1000 User manual
Welcome to your new Bison 1000 3D Printer!
Open in Awe
Unpacking Your Bison 1000
Printer & Accessory Checklist
1. Bison 1000
2. Adapter
3. Power Cable
4. USB Drive (Includes Tethonware software)
5. Resin Tray (In Printer)
6. Build Plate (In Printer)
7. Wide Scraper
8. Nitrile Gloves
9. Silicon Scraper
10. Rubber Scraper
11. Back Door Key
Unboxing
●Remove Straps from side of printer box.
●Carefully lift the top section of the box straight up until clear of
printer.
●Accessory box on top includes the power cable, adapter, USB
Drive, Nitrile Gloves, Back Door Key, multiple scrapers. Set Aside
●Carefully lift out and place Bison 1000 on level surface. The feet of
the printer can also be adjusted to make level.
_____________________________________________________________________________
Pro Tip: Save your box and packaging to safely transport printer in the
future.
_____________________________________________________________________________
Setting Up Your Printer
Remove protective plastic covering and styrofoam from inside printer.
Plug in provided power cable to your Bison 1000 and then connect to a
power outlet.
Flip switch to on position and press the power button on the front of the
printer.
_____________________________________________________________________________
Pro Tip: Never turn off printer via the switch on the back of your Bison 1000.
If necessary, hold down the power button on the front for 10 seconds to shut
down your machine.
_____________________________________________________________________________
Before printing
Make sure the resin tray is in place and secured down by the two latches on
the sides
Insert the build plate into place, handle facing forward, and tightening the
knob on the top.
Before printing make sure the resin tray is in place before installing the
build plate and after printing remove the build plate before removing the
resin tray to prevent spilling.
Install Tethonware from USB Drive provided with your printer onto your
computer
Safety
●Isopropyl Alcohol (IPA) is a flammable substance. When not in
use keep in a closed container and out of the reach of children.
●Use caution when removing print from build plate. Metal scraper
can slip and cause a nasty ouchie.
●Always wear nitrile gloves and safety glasses when handling
resin. Wash resin off of skin with plenty of soap and water.
●Do not look directly into the projected UV light.
●When providing maintenance to the Bison 1000 always shut off
and unplug from the power source. Never open up the printer
while it is still plugged in.
●Make sure to not overfill the resin tank as the build plate will
displace the resin further. Resin the spills over may damage the
printer.
Other manuals for Bison 1000
1
Table of contents
Other Tethon 3D 3D Printer manuals
