THOMSON THRAF575E User manual

AIR COOLER
THRAF575E
INSTRUCTION MANUAL
Please read these instructions carefully before using this appliance.
Please keep these instructions for future reference.
This product conforms to the requirements of directives 2014/35/UE
(repealing directive 73/23/CEE amended by directive 93/68/CEE)
and 2014/30/UE (repealing directive 89/336/CEE).

1. WARNINGS
The product must be installed in accordance
with the national wiring rules.
This unit is intended for household and
domestic indoor use only.
1. Use the appliance in a room size
corresponding to its cooling capacity.
2. Do not use the appliance near gas
appliances, fireplaces or flammable liquids.
3. Handle the appliance with care
4. Keep your appliance about 1 meter away
from any other electrical device to avoid
the risk of electromagnetic interference.
5. To avoid overheating, please put the
appliance about 50 cm away from a wall
and do not cover it.
6. Do not expose to direct or indirect heat
sources.
7. Do not use this appliance in wet area, and
not to have contact with water.
8. Do not submit the unit to strong shocks or
vibrations.
9. The plug must be easily accessible when
the device is connected.
10.Before connecting the appliance, check
that:
EN-02

- The supply voltage is the same as the
nameplate,
- The power supply socket is suitable to the
device,
- The cable plug is adapted to the socket
The product is intended only for a socket
with a main voltage of 230 volts (50 Hz).
11.Always remove the plug from the socket
when not in use.
12.Do not use the unit with a damaged cord or
plug
13.The appliance should be unplugged when
filling and cleaning
14.This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made
by children without supervision.
15.Never insert fingers, pencils or other objects
through the grid when the appliance is
running.
EN-03

16.This product complies with the requirements
of directives 2014/35/EU (repealing
Directive 73/23/EEC amended by Directive
93/68/EEC) and 2014/30/EU(repealing
Directive 89/336/EEC)
17.Never run the product in the presence or
within reach of unsupervised children.
18.If the power cord is damaged, it must be
replaced by the manufacturer, its service or
similarly qualified persons in order to avoid a
hazard.
19.User instructions should be provided with the
device so that it can be used safely.
20.Regarding the correct assembly of the
device, please refer to the corresponding
instructions.
21.For cleaning and maintenance instruction,
refer to the corresponding section.
EN-04

2. OPERATING CHARACTERISTICS
IMPORTANT
▪Fix the wheels on the product before usage.
▪Always make sure there is water in the tank when your air cooler is running in
COOL mode.
▪Do not move the appliance when it is filled with water. Empty before moving.
▪Use the air cooler on a stable, flat and level surface.
▪Never use the air cooler without the filters
2.1 DESCRIPTION
2.2 INSTALLATION
1. Pull the unit outwards from the carton and place it on a solid hot-proof horizontal surface.
2. Check if the accessories are complete, same as the accessories list.
3. Place the unit on a solid hot-proof horizontal surface. Take out the casters and caster
wrench to assemble.
Note: Casters with locks are for the two front holes and casters without locks are for the two
back holes at the bottom of the unit.
EN-05
Control panel
Display panel
Air Outlet
Water Level
Indicator
Castors
Water Tank Cover
Filter
Water Tank

4. Add water:
The appliance must be switched off before water filling
-Remove the water tank.
-If required, place the frozen ice boxes or ice cubes in the left side of the water tank to
increase cooling effect.
-Fill water tank with cold tap water, taking care to not exceed the maximum line marked
on the water tank, and not below the minimum level.
Using Ice Packs
Put the ice pack in the freezer until the liquid inside becomes the ice, then put
the ice pack in the water of the tank. During the cooling function, the air will
be cooler.
Note:
-ONLY PUT THE ICE PACKS and ICE CUBES on the left side compartment of the tank as the
right side is the pump compartment and must not block the pump moving structure.
-Water level must be between the MIN and MAX line.
-After some time operation, dust and dirt may occur in water tank. It is recommended to
change water and clean water tank frequently.
5. Only use the unit with correct AC outlet.
6. Insert the plug pin into a wall socket, a small beep sound can be heard and the unit is on
standy mode.
Note:
- To protect against electric shock, do not remove plug from wall outlet with wet hand.
- Unplug from outlet before moving the unit.
EN-06

2.3 OPERATION
Control panel
Control panel Remote Control
Remote control panel has the same functions as the unit control panel
Insert the plug pin into a wall socket and turn on the power switch which is at the side of the
unit. A small beep sound can be heard and the power indicator will be on.
POWER : Press once this button to make the unit ready for working. It will start up with MID
in 3 seconds and then revert to work under the memorized status. If first time use, it will start
up with MID in 3 seconds and then work with LOW. Press again this button to turn OFF.
SPEED :Press this button to select desired fan speed,
LOW →MID →HIGH →LOW in turn. At the same time, display panel shows
, or , or .
SLEEP MODE : Press this button to select desired wind mode, it works as per the presetted
computer program, alternating between different fan speeds.
UP/DOWN : Press once this button to make vertical swing of louvers, the indicator will
be displayed. Press again for fixed air direction.
LEFT/RIGHT : Press once this button to make horizontal swing of louvers, the indicator
will be displayed. Press again for fixed air direction.
EN-07

COOL : Press once this button to start the evaporative cooling function. Press again this
button to cancel.
TIMER : It can be set between 0.5 to 8 hours, increased by 0.5 hour intervals. When the
digital display shows 8 hours, press again this button to cancel.
DISPLAY LIGHT ON/OFF : Press once this button to light-off the display, press one more
time to light-up again.
CHILD LOCK : Press this button 3 seconds to lock the control panel in case children mis-
control. Press 3 seconds again to cancel this function.
3. CLEANING AND MAINTENANCE
Always disconnect the appliance from the mains by switching it off and removing the plug
from the power outlet before cleaning.
Unplug from outlet.
No water on the control panel.
Cleaning the filtration mesh
1. Remove plug from wall outlet.
2. Catch the filtration mesh handle and pull upwards.
3. Clean filtration mesh with mild detergent and soft brush.
4. Make sure filtration mesh is completely dry before installing.
Note: After long time operation, the filtration mesh becomes clogged with dust and dirt,
which will greatly affect the unit’s performance. It is recommended to clean the filtration
mesh frequently.
Cleaning the water tank
1. Remove plug from wall outlet.
2. Pull out the water tank.
3. Clean the water tank with a little mild detergent on a towel and then rinse in water.
4. Put the water tank in place after cleaning.
Note: After some time operation, dust and dirt may occur in water tank. It is recommended to
change water and clean water tank frequently.
EN-08

Cleaning the body
1. Remove plug from wall outlet.
2. It is advisable to use a neutral detergent and a soft cloth and to rub dry. Do not use
solvents, acidic detergents, petrol or alcohol etc. to clean the plastic components, as
these could be deformed or damaged.
3. Cleaned with a damp cloth and allow to dry.
If you do not use the product for a long period, please empty the water tank.
4. TROUBLE SHOOTING
If there is something wrong during operation, it may not be the unit’s problem. You may
check against the following list before send for repair
Problems
Possible reasons
Solutions
Not working
1. The plug is not securely
inserted into the socket or
not connected well.
2. The “POWER” button is not
pressed.
1. Insert the plug pin into the wall
socket and make sure it is
connected well.
2. Press “POWER” button after
plugged.
Air refreshing
effect not good
1. The filtration mesh is
clogged with dust and dirt,
which affects the unit’s
performance.
2. The air vent is obstructed.
1. Clean the filtration mesh.
2. Remove the foreign objects from
the air vent.
Note:
1. If the problem can not be found in the list or it persists, please contact service center
or a qualified technician for further inspection.
2. Do NOT open and repair the unit by yourself.
Never attempt to disassemble or repair the unit yourself. In the case of not competent repair,
the guarantee is void.
EN-09

5. TECHNICAL SPECIFICATIONS
Model
THRAF575E
Tension
220-240V~
Frequency
50Hz
Power
65W
Timer
8h
Water tank capacity
6L
Class II
The European directive 2012/19/CE on Waste Electrical and Electronic
Equipment (WEEE), requires that old household electrical appliances must not be
disposed in the normal unsorted municipal waste stream. Old appliances must be
collected separately in order to optimize the recovery and recycling of the materials
they contain and reduce the impact on human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that
when you dispose of the appliance it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the
correct disposal of their old appliance
The warranty does not cover the wear parts of the product, nor the problems or damage
resulting from:
(1) surface deterioration due to normal wear and tear of the product;
(2) defects or deterioration due to contact with liquids and corrosion caused by rust;
(3) any incident, abuse, misuse, alteration, disassembly or Unauthorized repair;
(4) improper maintenance, improper use concerning the product or connection to an
incorrect voltage;
(5) any use of accessories not supplied or not approved by the manufacturer.
The guarantee will be cancelled if the nameplate and / or serial number of the product are
removed.
THOMSON is a trademark of TECHNICOLOR S.A used under license by ADMEA
EN-10