THOMSON SPEEDTOUCH D50 User manual

Additional handset for
D150
D50
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 1

2
1. GETTING STARTED
Your telephone is compliant with the DECT™*
standard. It is designed to transmit and receive telephone calls. It
is the additional handset for the which has to
be connected to the UK public telephone network.
1.1 INSTALLING ...
... the handset
lInsert the batteries as indicated in the diagram (also refer to
the marking inside the battery compartment), then replace the
cover.
Inserting the batteries
! Only use rechargeable batteries with exactly the same
specifications as those supplied with the product.
Using non-rechargeable or non-conforming batteries
(see the "Safety" chapter) can damage the product and
presents a health hazard.
Failure to comply with this recommendation will invali-
date the manufacturer's warranty.
+
-
-
++
-
D150
D50
ENGLISH
* DECT is a trademark registered by ETSI.
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 2

Never dispose of batteries in a fire: risk of explosion.
The batteries could split or leak if incorrectly inserted,
opened or exposed to heat.
... the charger
lConnect the power cable to the connector on the side of the
charger.
lPlug the mains adapter into the wall socket and place the
handset on the charger.
Before using it for the first time, we recommend that you leave the
handset to charge up on the charger for 24 hours in order to
optimise battery performance and longevity.
1.2 REGISTERING YOUR WITH
THE BASE OF THE
Registering a non-registered handset
From a handset which has already been registered:
lPress to enter the menu.
lSelect "BS Setting" and press to confirm.
lEnter "MASTER PIN:" 1590 (by default) and press to
confirm.
lSelect "New HS" and press to confirm.
lEnter the PIN code: 1590 (by default) and press to
confirm.
lSelect a number from 1 to 9 or "Auto" and press to
confirm.
D150
D50
3
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 3

The numbers which have already been assigned are marked
by "–".
Then, from the handset which has not yet been registered: you
have about 2 minutes to register the handset.
lPress to enter the menu.
lSelect "HS Register" and press to confirm.
lSelect the base with which the handset is to be associated and
press to confirm.
"A message will appear on the screen within 15 seconds
and press .
lEnter the PIN code: 1590 (by default) and press to
confirm.
"The number of the handset will be displayed within
15 seconds.
If this fails, repeat the complete operation.
FOR MORE DETAILS ON USING THIS ADDITIONAL HANDSET,
PLEASE REFER TO YOUR MAIN MANUAL.
In case of problem, you can call the hotline on the following
number: , from Monday to Friday, from
9a.m. to 5p.m. (call billed at current rates).
The store where you bought your is also able to
inform you and provide after-sales service.
D50
1300 302 699
D150
4
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 4

2. WARRANTY
complies with requirements of the Australian
Communications Authority as certified by the A-Tick.
You are covered by a legal warranty for this product and for all
information concerning this warranty, please contact your reseller.
Notwithstanding other applicable statutory warranties, the reseller
warrants that the product complies with the applicable technical
specifications and is free from any defect in workmanship and
materials for a period of twelve (12) months from the date of pur-
chase shown on the invoice or receipt. You should therefore keep
your invoice or till receipt specifying the date of purchase of the
product and the name of the reseller. Nonetheless, if the statuto-
ry warranty in force in your country exceeds twelve (12) months,
the statutory warranty in force in your country will apply in lieu of
the manufacturer's warranty.
The manufacturer undertakes to repair or replace at its option the
defective product or part thereof with a comparable product or
part or at least equivalent as to the performances and functiona-
lity. The replacement product or parts, which may be new or
reconditioned, are warranted for a period expiring either simulta-
neously with the initial warranty of the concerned product or part
thereof or three (3) months after delivery of such repaired product
or part, which ever is later. Moreover, upon proof evidence, the
initial warranty period may be extended for the period you have
not been able to use the product due to the repair. All product or
parts that are replaced become the property of the manufacturer.
D50
5
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 5

6
This warranty does not cover damage caused by:
Non-compliance with the instructions for use, installation or
maintenance of the product, in particular regarding the power
supply and climatic conditions.
Improper maintenance of energy sources and of the general
electrical installation.
Acts of vandalism, lightning, fire, humidity, bad weather.
Use of the product in combination with, or integration of the
product into, equipment not supplied by the reseller, unless
such combination or integration has been expressly approved
in writing by the reseller.
Use of the product for a purpose other than that for which it is
intended.
Faults and deterioration caused by normal wear and tear, a
shock or a fall.
Product malfunctioning due to external causes (e.g., radio-
electric interference produced by other equipment, variation in
voltage of the mains supply and/or telephone line).
Changes made to the product, including mandatory changes.
Product from or on which the brand or serial numbers have
been removed or altered.
Defects as a result of other goods and services being
connected to the product which disturb or affect the predicted
level of service.
UNLESS OTHERWISE STIPULATED BY LAW, ANY AND ALL
WARRANTY PROVISION OTHER THAN THOSE MENTIONED
HEREIN ARE EXPRESSLY EXCLUDED.
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 6

7
3. SAFETY
This device is supplied by an AC/DC mains adapter in conformity
with standard EN 60950. The network voltage is classified as a
hazard by the criteria of this standard and its output as SELV
(Security Extra Low Voltage). In the event of danger, the mains
adapter acts as a 230V power isolating device. It should
therefore, as a precaution, be installed close to the appliance and
be easily accessible.
If the mains adapter fails, it must be replaced by an identical
model.
If not connected to the mains power or if there is a mains power
failure, installations with cordless handsets will no longer work.
You will then be unable to make or receive calls in the event of an
emergency. This is why we recommend that you also have a
conventional telephone as a backup.
NOTE:
Characteristics of the electric power supply of the charger:
- Input: 230 V AC / 50 Hz / 59 mA
- Output: 7.5 V DC / 210 mA
The appliance is designed for connection to a class TRT3 analo-
gue telephone line (telecommunications network voltage) as defi-
ned by the standard EN 60950.
Battery type: rechargeable batteries NiMH AAA 1.2 V / 650 mAh.
Used handset batteries must be disposed of in compliance
with current environmental protection regulations. You
should return your batteries to your reseller or dispose of
them at an approved recycling centre.
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 7

Do not attempt to open the batteries, as they contain chemical
substances. In the event of leakage, avoid contact with the skin,
eyes, mouth and nose. In the event of contact, rinse the affected
part for twenty minutes in running water and seek medical
assistance immediately.
Clean the product with absorbent paper or a dry cloth and contact
your reseller for replacement batteries.
!Do not use your telephone to notify a gas leak when you
are in the vicinity of the leak.
It is recommended that you avoid using this device during electri-
cal storms.
8
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 8

© Thomson Telecom - Reproduction interdite / All rights reserved / Reproducción prohibida THOMSON et sont des marques déposées / THOMSON and are registered trade marks / THOMSON y son marcas registradas Le constructeur se réserve le droit de modifier les caractéristiques de ses produits en vue d'y apporter des améliorations techniques ou de respecter de nouvelles réglementations. / The manufacturer reserves the right to modify the specifications of its products in order to make technical improvements or comply with new regulations. / El fabricante se reserva el derecho de modificar sin previo aviso las características de sus productos para introducir mejoras técnicas o cumplir con nuevas regulaciones oficiales.
Ref: XX-XXX-XXXX-XX - 29/11/04
STD50_AU_Ed01.pdf 29/11/04 12:00 Page 9

Thomson Telecom Australia
1st Floor
Building B
1 Moorebank Avenue
Moorebank NSW 2170
Australia