Tisira TCH60X Series User manual

User manUal
rangehood series
TCh60X & TCh90X
IMPORTANT // Please ensure that you read through this user manual prior to installation and use. This
manual contains important information to ensure optimal performance and keep you safe. Please retain your
proof of purchase, as this will be required in the event that you require warranty service. Remember to retain
this manual for future reference.
www.tisira.com

172
300
222
Min 700
Max 1080
500
600/900
400
3 4 51 2
0

pg 6www.tisira.com | tisira
www
.tisira.com
mainTaining
YoUr rangehood
IMPORTANT // Switch off and unplug the rangehood at the powerpoint before undertaking
any cleaning or maintenance on the unit.
LIGHT BULB REPLACEMENT
Switch off the power to the canopy hood and allow the bulb to cool.
Use a small bladed screwdriver to prise off the light cover, taking care not to damage the
surrounding material.
Use a cloth to remove the bulb.
Replace with a new bulb using a cloth. Do not touch the bulb with fingers.
Snap the cover back in place.
GENERAL MAINTENANCE
To prevent any surface damage never use any abrasive products or products that contain
soda, acids, chlorides or solvents.
To clean the surface of the appliance use a mild detergent in warm water, with a soft
non-abrasive cloth.
Only use a damp cloth as use of excessive water can penetrate the unit and cause damage.
Dry surface thoroughly after cleaning with a soft cloth to prevent marking of the surfaces.
FILTER MAINTENANCE
To ensure that the rangehood performs at it’s best, filters need to be cleaned cleaned at
least monthly or more frequently with heavy use
The filters can be cleaned using hot soapy water and a soft nylon brush or placed in a
dishwasher.
NOTE // Cleaning the filters in the dishwasher may cause permanent discoloration of the
surface. This does not in any way affect the performance of the filters.
Charcoal filters cannot be cleaned or reused. Replace filters every 3-6months dependant on
use and cooking style. Please dispose of used filters responsibly.
NOTE // Oversaturated filters are a fire hazard so regular cleaning/replacement is a must.

pg 7
tisira | www.tisira.com
www
.tisira.com
eleCTriCal
ConneCTion
NOTICE // This appliance must be connected
only by a licensed electrician and installed
in accordance with the manufacturers
instructions.
Installation, repairs and other work by
unqualified persons could be dangerous,
for which the manufacturer cannot be
held liable.
Ensure power is not supplied to the
appliance until after installation or
repair work has been carried out.
Do not connect the appliance to the
mains electricity supply by an extension
lead. These do not guarantee the
required safety of the appliance.
The connection data is given on the data
plate. This is visible when the grease
filters have been removed. Ensure that
this data matches the household mains
supply.
Connection of this appliance should be
made via a suitable isolator or a double
pole fused spur connection unit which
complies with national and local safety
regulations and the On-Off switch should
be easily accessible after the appliance
has been built in.
When switched off there must be an
all-pole contact gap of 3 mm in the
switch (including switch, fuses and
relays according to EN 60335).
If the switch is not accessible after
installation (depending on country), an
additional means of disconnection must
be provided for all poles.
For extra safety it is advisable to install
a suitable residual current device (RCD).
Contact a qualified electrician for advice.
IMPORTANT // This appliance is supplied
for connection to a 230V~50Hz supply.
The wires in the mains lead are coloured in
accordance with the following code:
Green/Yellow = Earth
Blue = Neutral
Brown = Live
WARNING // THIS APPLIANCE MUST BE
EARTHED

A
B
C

PROOF OF
PURCHASE

pg 10 www.tisira.com | tisira
www
.tisira.com

pg 11
tisira | www.tisira.com
NOTES

CONTACT
DETAILS
www.tisira.com
VERSION 3.0