TKB Home TZ68 User manual

This plug-in ON/OFF Module in a transceiver which is a Z-Wave enabled device
and is fully compatible with any Z-Wave enabled network. Z-Wave enabled devices
displaying the Z-Wave logo can also be used with it regardless of the manufacturer,
and ours can also be used in other manufacturer's Z-Wave enabled networks. Remote
on/off control of the connected load is possible with other manufacturer's Wireless
Controller. Each module is designed to act as a repeater. Repeaters will re-transmit
the RF signal to ensure that the signal is received by its intended destination by
routing the signal around obstacles and radio dead spots.
Adding to Z-Wave Network
In the front casing, there is an ON/OFF knob which is used to carry out inclusion,
exclusion or association. Put a Z-wave Wireless Controller into inclusion/exclusion
mode, press the knob on the Module to complete the inclusion/exclusion process.
On/off knob
LED indicator
Installation
1.Plug this ON/OFF Module into a wall outlet near the load to be controlled.
2.Plug the load in to the Module. Make sure the load to be controlled cannot exceed
2990/3500 watts.
3.Turn the knob or switch on the load to the ON position
TZ68 ON/OFF MODULE

Programming
The ON/OFF knob allows the user
- Turn on or off the load attached
- Include or exclude the Module from the Z-Wave system
- Control other Z-Wave enabled devices
Troubleshooting
The Module not working and
LED off
The Module LED illuminating,
but cannot control the ON/OFF
Switch of the load attached
1.The Module is not
plugged in to the
electrical outlet
properly
2. The Module is out
of order
Check if the load plugged
into the Module has its
own ON/OFF switch
1.Check p o w e r
connections
2. Don't open up
the Module
and send it for
repair.
Set the ON/OFF switch
of the load attached to
ON
The Module LED illumina tin g,
but the Detector cannot control
the Module
1.Not carry out association
2.Frequency interference
1.Carry out association
2 . Wa it f o r a w h i l e to
re-try
Symptom Cause of Failure Recommendation
4.To manually turn ON the ON/OFF Module, press and release the ON/OFF knob.
The blue indicator LED will turn on , and the load plugged into the module will also
turn ON.
5.To manually turn OFF the Module, simply press and release the on/off knob. The
blue indicator LED will turn OFF and the load plugged into the Module will also turn
OFF.
Specification
Operating Voltage
Maximum Load
Range
Frequency Range
230V/50Hz
2990 W for UK, 3500W for Germany France,
Minimum 30m line of sight
868.42MHz
Warning:
1.Do not dispose of electrical appliances as unsorted municipal waste, use separate collection
facilities.
2.Contact your local government for information regarding the collection systems available.
3.If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak
into the groundwater and get into the food chain, damaging your health and well-being.
4.When replacing old appliances with new once, the reta il er is l egall y obl ig ated to take back
your old appliance for disposal at least for free of charge.
Socket Type
Since the socket type for each country in Europe varies, refer to the outline for each socket
suited for each country as follows:
Germany
TZ68G U.K TZ68E
France
TZ68F