Toa RS-480VSET User manual

TOA Electronics, Inc.
INSTALLATION MANUAL
VIDEO INTERCOM SYSTEM
Note: For operation of the system, refer to the N-8000 series operating instructions.
S-480V should be setup as a substation connected to N-8400 S in the N-8000 setting software.
1. GENERAL DESCRIPTION
The S-480VSET consists of an intercom substation S-480V, and a video substation interface unit IF-480V.
The S-480V is an intercom substation with a color camera which is designed for indoor and outdoor use in
combination with the IF-480V, and the N-8400 S substation interface unit. It requires only one CAT5 cable to
connect between the S-480V and the IF-480V.
2. SPECIFICATIONS
2.1. Basic Speci ications
[RS-480V]
Power Source Supplied from IF-480V
Call Button Momentary (Emergency call: Press twice within 400 ms.)
ated Input 1 W
Control Output Open collector, Maximum controlled voltage: 30 V DC, Control current: 30 mA
Internal Speaker Cone-type
Internal Mic Electret condenser type
Camera esolution 520TVL
Camera Angle 170° horizontal
Minimum Illumination 0.008 lux/f2.0
Function Day & night dual mode auto switch
Indicator When called: Status indicator (red) flashing
In conversation: Status indicator (red) is lit
Wiring CAT5 cable, J45 female connector attached
Transmission ange 3,000ft (AWG24)
Operating Temperature –10 to +50°C (Temperature range not to freeze the speaker and switch)
Finish Panel: Stainless steel, hairline
Call button: Metal, silver
Dimensions 4.72”(w) x 4.72”(h) x 1.99”(d) (120 x 120 x 50.5mm)
Weight 1.30 lb (605g)
Supplied Accessories No.6-32UNC x 18 ... 4, Machine screw M4 x 25 ... 4
Applicable Box 2-gang electrical box: YC-302 (option)
[IF-480V]
Power Source Supplied AC adapter must be used
Indicator Power LED (green), Lock LED (blue), Color LED (orange)
Connectors J45 (to S-480V), emovable terminal block 4P (to N-8400 S),
BNC (Video out) x2
Finish Anodized aluminum, Black
Dimensions 4.13”(w) x 1.30”(h) x 5.00”(d) (105 x 33 x 127mm) *Not including connectors.
Weight 10.00 oz (285g)
Supplied Accessories AC adapter
Options ack mount plate: MB-480V4 (up to four IF-480Vs are mountable in 1 unit)
RS-480VSET

TOA Electronics, Inc.
2.2. LED Indications
3. CONNECTIONS
3.1. System Components
3.2 External Relay
S-480V IF-480V
AC adapter (accessory)
CAT5 Cable (Max. 3,000ft)
N-8400 S
Twisted pair cable (2-pair)
To monitor displays, video
recorders, or video switchers Coaxial Cable
IF-480V
COLO : Orange LED lit when the color signal strength is good
and
is received properly.
LOCK: Blue LED lit when the video signal strength is good
and is received properly.
POWE : Green LED lit when the IF-480V is power on.
When the COLO or LOCK LED is off, the following problems are suspected:
• The cable length from the S-480V is too long.
• The problem of the camera or the cable.

TOA Electronics, Inc.
4. WALL MOUNTING
Mount the S-480V to an electrical box mounted in the wall.
Notes Dimensional Diagram
6. MOUNTING LOCATIONS
Do not install the S-480V in the following environments in order to achieve the maximum performance of the
camera and capture the target objects clearly:
• Locations where the camera is in direct sunlight.
• Locations where the backlight occurs against the target objects.
• When using the PA paging function, keep the
switch panel as far away from the PA paging
speaker as possible to avoid feedback.
• When installing the S-480V at outdoor or
locations where it gets wet, tightly seal the panel
edges. Also, provide a weep hole at the
underside of the mounting box to permit water to
drain out.
4.72”
[120mm]
1.81”
[46mm]
4.72”
[120mm]
3.29”
[83.5mm]