Tommee Tippee Closer to Nature Perfect Prep Machine User manual

WATER
HOPPER
closer to nature perfect prep machine
INSTRUCTIONS FOR USE
START / STOP
BUTTON
SETTING
DIAL
WARNING
LIGHTS
ACTION
BUTTONS
DISPENSER
OUTLET
DISPENSER
OUTLET
WATER
TANK
WATER
FILTER
BOTTLE
STAND
WARNING LIGHTS ACTION BUTTONS
CHANGE
FILTER CLEANING
MODE
FILTER
VOLUME
RESET
DECALC/
DESCALE
WATER TANK
HOT
WATER LEVEL
LOW
DECALC/
DESCALE
CLEANING
MODE
FOR DOMESTIC USE ONLY - NOT INTENDED FOR COMMERCIAL USE
IMPORTANT WARNINGS - Keep this
instruction sheet for future reference as
it includes important information.
• Do not immerse in water.
• This appliance can be used by children
aged from 8 years and above and
persons with reduced physical,
sensory or mental capabilities or lack
of experience and knowledge if they
have been given supervision or
instruction concerning use of the
appliance in a safe way and
understand the hazards involved.
Children shall not play with this
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
• Keep the appliance cord out of reach
of children.

1. SET UP AND
CLEANING
2 3 4
Place a container under the
dispenser outlet to capture the
water used to clean the system (at
least 1 litre capacity).
Plug in the unit, the tank empty
warning light will illuminate.
With the water hopper in place (but
not the filter) fill the hopper with 1
litre of freshly boiled water - HOT
WATER -
Wait for the tank empty warning
light to go out. The water tank hot
light will illuminate.
5 6 7 8
Press the cleaning mode button and
hold for 2 seconds. The cleaning
mode light will illuminate.
Wait whilst the boiled water is
emptied from the tank, through the
dispenser, into the container that you
placed under the outlet in step 1.
The tank empty warning light will
illuminate once the water has
flushed through the system.
Discard the water captured in your
container and replace it under the
dispenser.
9a 9b 10 11
12
Remove the water hopper and
fit the filter*.
Replace in the water tank.
Fill the hopper with COLD WATER. Wait for the tank empty warning
light to go out.
Press the start/stop button. A red
light will flash.
13 14
The appliance will dispense an
amount of hot water.
Press the start/stop button again. A
green light will flash and an amount
of water will be dispensed to finish
the cycle.
Press the filter volume reset button
for 2 seconds to clear the memory.
Discard dispensed water.
Your system is now ready to use.
Before first use you need to run a cleaning cycle – which should take approximately 10 minutes. You should
clean your unit as part of the set up and again whenever you replace your filter. For hygiene and safety
reasons you should always clean your unit if it has been unused or in storage for longer than 2 weeks.
*Handling the filter cartridge by the top only:
• Remove the filter cartridge from packaging
• Remove sticker from the top of filter
• Fill a bowl with potable (drinking) water
• Fully submerge the cartridge in the water
• Gently agitate until the bubbles cease
1
15
FILTER
VOLUME
RESET

2. USAGE Before each use you must ensure that your water tank is above the minimum fill mark.
Water to fill the unit must come from the cold tap.
Check the water level and top up if
necessary with COLD WATER. When
filling the tank, you must always fill the
hopper and as the water passes through
the filter you can regularly top it up.
1
Turn the dial to select the feed
size you require (4fl oz –11fl oz).
2
Position your sterilised bottle
under the dispenser. Adjust bottle
stand if necessary. (Bottle neck
should sit close to the outlet).
3
Press the start/stop button. A red
light will flash and a volume of
HOT WATER is dispensed into
your bottle.
4 5
The light will change to solid red
and there will be a double beep
to indicate the end of the first
stage. You will need to make up
your feed within 2 minutes.
Carefully remove the bottle from
the stand and measure the
correct number of formula
scoops into the bottle.
6 7
Screw the sterilised milk storage
lid onto the bottle and ensure
that the lid is tight. Be careful
when handling hot liquid.
Shake well until the formula
powder has dissolved.
8 9
Remove the milk storage lid and
replace your bottle onto the
bottle stand.
10 11
Always check that the amount
dispensed is consistent with the
size of feed you have selected on
the dial. Add the sterilised teat,
screw ring and hood and shake.
12 13
For your child’s safety always
check food temperature before
feeding by testing on a sensitive
part of your skin.
Your bottle is now ready to serve.
Make sure you discard any
unwanted feed as per the formula
manufacturers recommendation.
Press the start/stop button again.
The red light will go out and the
green light will flash. If this button
is not pressed within 2 minutes of
the hot water being dispensed a
long beep will sound. If the alarm
sounds you should discard the feed
and repeat the process from step 1.
Wait whilst the remainder of
water is dispensed. Once
completed, there will be a
double beep and the green
light will change to solid.
If at any point you need to stop the perfect prep™ machine you can
do so by pressing the start/stop button. The pump may continue to
run for a few seconds and the green light will illuminate to show that
the process has ended. It will not be possible to restart the machine
for 20 seconds. Should you have to stop the perfect prep™ machine
please discard of any feed.
HOW TO STOP THE PERFECT PREP™ MACHINE
For a cool tank keep the unit out of direct sunlight and away from
sources of heat. Fill with COLD WATER from the fridge. Regularly top
up with COLD/COOLED WATER.
HINTS AND TIPS

Your unit comes with a water filter which lasts 150 litres (approximately 3 months).
3. MAINTENANCE Replacing your filter.
KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE AS
IT INCLUDES IMPORTANT INFORMATION.
Information on the disposal for Waste Electrical & Electronic
Equipment (WEEE)
This symbol on the products and accompanying
documents means that used electrical and electronic
products should not be mixed with general
household waste.
For proper disposal for treatment, recovery and recycling, please
take these products to designated collection points where they
will be accepted on a free of charge basis. In some countries you
may be able to return your products to your local retailer upon the
purchase of a new product.
Disposing of this product correctly will help you save valuable
resources and prevent any possible effects on human health and
the environment, which could otherwise arise from inappropriate
waste handling. Please contact your local authority for further
details of your nearest collection point for WEEE.
Penalties may be applicable for the incorrect disposal of this
product in accordance with national legislation.
The appliance is designed for domestic use only. It should not
be used for commercial purpose.
Do not immerse in water.
Warning! Children should be supervised to ensure that they do
not play with the appliance
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to aviod a hazard.
The product is fitted with a BS 1363 mains plug containing a 13A
fuse. If it ever becomes necessary to replace the fuse, only use fuses
that are marked BS 1362, and rated at 13A. In the unlikely event
that this plug is not suitable for the sockets in your home, it should
be removed and a suitable plug fitted as follows:
The wires of the mains lead are coloured in accordance with the
following code:
GREEN AND YELLOW – EARTH
BLUE – NEUTRAL
BROWN – LIVE
As these colours may not correspond with the coloured markings
sometimes used to identify the terminals in the plug, connect as
follows. The wire coloured GREEN AND YELLOW must be
connected to the terminal marked E or by the earth symbol or
coloured GREEN or GREEN AND YELLOW. The wire coloured BLUE
must be connected to the terminal marked Nor coloured BLACK.
The wire coloured BROWN must be connected to the terminal
marked Lor coloured RED.
If you are in any doubt about how to wire a plug or replace a fuse
safely, consult a qualified electrician.
DO’S & DON’TS
Do’s
✔Before first use clean the unit following points 1 to 15 in the set
up and cleaning section.
✔Always ensure good hygiene by washing your hands and
work surfaces before handling the water filter.
✔This product is intended for use with tommee tippee closer to
nature water filters which are available from all perfect prep™
machine stockists. Use of any other water filter with this
product could put your child’s health at risk.
✔A solid red light will indicate when the filter has enough life to
filter 30 litres of water. When the change filter light flashes red,
the filter must be changed immediately for your child’s safety
and health.
✔Always adjust the height of the bottle stand to ensure that
the bottle neck is close to the dispenser outlet to maintain the
temperature of the water and avoid any splashes.
✔Dispose of the filter in general household waste.
✔Only use potable water (drinking water).
✔To clean the outside of the unit, wipe with clean damp cloth.
✔For your child’s safety always check food temperature before
feeding by testing on a sensitive part of your skin.
✔Be careful when handling boiling water.
Don’ts
✘Do not allow the water tank to be contaminated. The
inside of the unit should only be cleaned by following the
cleaning process in steps 1-15 in the set up and cleaning
section of this leaflet.
✘Do not clean with solvents or harsh chemicals.
✘This appliance is intended for use in a kitchen and not
suitable for use in a nursery.
✘This unit makes very hot water. Keep hands and other body
parts away from the dispenser outlet.
✘Use cold water only. Do not use water that is over 25°C other
than when cleaning the unit using the set up and cleaning
process. If water over 25°C is used, the unit will automatically
turn itself off. If this happens allow the unit to cool and restart.
✘Do not overfill past the max mark on the water hopper.
✘Do not pour water down the back of the unit.
✘Do not pour water directly into the water tank. The
water must go into the water hopper.
A red change filter warning light
will illuminate when the filter
needs replacing soon. If this light
flashes, the filter must be
changed immediately.
Replacement filters are available from all closer to nature perfect prep™ machine stockists.
Press the cleaning mode button for
2 seconds to empty the tank
(ensure a suitably sized receptacle
is under the dispenser outlet to
collect the water). Then press the
filter volume reset button for 2
seconds to clear the memory.
Remove the old filter from the
hopper and discard. Replace the
hopper (without filter).
Follow the cleaning cycle steps as
per SET UP – fitting your new
filter at stage 9.
21 3
Made in China
Leaflet No. 0423708
Jackel International Limited trading as Mayborn Group,
Northumberland Business Park West, Cramlington
Northumberland NE23 7RH, UK
A red warning light will illuminate when the unit requires descaling soon.
If the light flashes, you should descale immediately.
1. Remove the filter.
2. Fill the water tank with 0.5 litres of distilled white vinegar (4 or 5%).
3. Place a jug under the dispenser outlet.
4. Press the descale button for 2 seconds and the system will run a descale process.
During the descale process the red descale light will continue to flash.
5. At the end of the descale process an alarm will sound and the descale LED will switch off.
6. The red cleaning mode light will flash.
7. Fill the tank with 1 litre of freshly boiled water.
8. Follow the cleaning cycle steps as per stages 5-15 of the set up and cleaning process.
9. Again, fill the tank with 1 litre of freshly boiled water.
10. Repeat the cleaning cycle steps as per stages 5-15 of the set up and cleaning process.
11. The current filter can be refitted.
4. DESCALING The descaling process will remove deposits of calcium and other minerals in
the system that may affect its performance.