TomTom R-Link 300 299 User manual

Renault / Opel / Smart
R-Link (TOMTOM) interface
installation manual
Article code: 300 299
(SEP 2017)

2
Example installation
Check LCD type before installation

3
Remove the screws of the plastic cover

4
Remove plastic cover from LCD housing

5
Remove the screws of LCD housing


6
Unlock the LCD ribbon cable very carefully
Avoid damage and do not use any solid tools!


7
Connect the switchboard as shown below
Be careful with the ribbon cables!


8
Connect the original LCD ribbon cable with the right cable of the switchboard


9
Fix the switchboard on the LCD housing as shown below


10

Fix the plastic cover back on LCD housing

11
Connect the power cable in between
and the interface as shown below

12
Active needed video inputs like following:
- CAM: DIP switch 5 down
- AV1: DIP switch 2 down
- AV2: DIP switch 3 down
* DIP switch 1,4,6,7,8 must set up (not used).
Camera / Video inputs:
When interface is not reacting by CANbus, reverse wire (green) should be connected with an
analog (12V) reverse signal. It's also possible to connect the other power signals without
CANbox, analog as below:
Yellow + red: +12V acc.
Black: ground
Green: +12V reverse
White: optional (+12V, switch from OEM to AV1 / AV2)
Grey: n.c.
Interface menu settings:
Installer may use the 3 keys MENU, DOWN, UP on the ( bottom or side)
interface box to change external (camera) image settings if needed.