TOTALINE BASIC 1H User manual

®
Operating Manual
Mode d'emploi
Manual de Uso
Totaline ®Basic 1H/1C & 2H/1C
Non-Programmable Thermostats
Thermostat non programmables
Termostatos no programables
570-207 IIIIIIIIIIIIIIIIIIIIIIII
69-2256EFS

Totaline Basic 1H/1C & 2H/1C
This manual covers the following models:
P310-0110: For 1-Heat/1-Coot systems
P310-0210: For 2-Heat /1-Cool heat pump systems
(Remove the thermostat from its wallplate to find the model number.)
CAUTION: EQUIPMENT DAMAGE HAZARD.
To prevent possible compressor damage, do not use Cooling mode when the
outdoor temperature is below 50 °F (10 °C).
E0r assistance with this product please visit www.totaline.com
Read and save these instructions.
® U.S. Registered Trademark. Patents pending.

Operating Manual 570-207
i_1qFJ__
Overview
Thermostat features ............................. 1
Quick reference to controls .................. 2
Quick reference to display. ................. 3
Operation
System switch (Heat/Cool) ................... 4
Fan switch (Auto/On). ........................... 5
Temperature controls ............................ 6
Compressor protection ......................... 7
Appendices
Battery replacement ............................. 8
In case of difficulty ................................ 9
Customer assistance .......................... 10
Limited two-year warranty ................... 11

Totaline Basic 1H/1C & 2H/1C
Your new Totaline thermostat has been designed to give you many years of
reliable service and easy-to-use, push-button climate control.
Features
• Backlit display is easy to read
• Displays ambient (measured) temperature at all times
• One-touch access to setpoint temperature
• Built-in compressor protection

Operating Manual 570-207
f2Tnm_IT__ i_ _ _
Screen
Lit for 12 seconds when
you press any button. Up/Down buttons
Press to adjust temperature
System switch (see page 4)
• Cool: System is in Cooling mode.
• Off: System is off.
• Heat: System is in Heating mode.
•Em Heat: System is in Emergency Heat mode.
Fan switch (see page 5)
• On: Fan runs continuously.
• Auto: Fan runs onlywhen heating or cooling is
activated.

Totaline Basic 1H/1C & 2H/1C
Low-battery warning (see page 8)
System status
•Cool @ : Cooling is activated. *
• Heat 8 : Heating is activated. *
• Stg2: Auxiliary heat is activated. **
Setpoint indicator
Appears when the setpoint
temperature is displayed.
Temperature display
The ambient (measured)
temperature is normally
displayed. To view the
setpoint temperature, press
either of the temperature
adjustment buttons once.
The setpoint temperature
will appear for five seconds.
* If Heat 8 or Cool _ is flashing, compressor protection is engaged (see page 7).
** Applies to P310-0210 model only.

Operating Manual 570-207
Use the System switch to place the system in
one of the following modes.
• Cool: System is in Cooling mode.
• Off: System is off.
• Heat: System is in Heating mode.
• Em Heat: System is in Emergency Heat
mode. Only auxiliary heating can be
activated. The compressor is disabled. (This
mode is available on the P310-0210 model
only.)
CAUTION: EQUIPMENT DAMAGE HAZARD
Do not use Cooling mode when the outdoor temperature is below 50 °F (10 °C).

!ii
Totaline Basic 1H/1C & 2H/1C
i_/ o i' ii
l__J o ,, iii
Use the Fan switch to select the fan
operation.
•Auto: The fan runs only when heating
or cooling is actually taking place
(commonly used setting).
• On: The fan runs continuously. Use
this setting for improved air circulation
or for more efficient air cleaning.

Operating Manual 570-207
_ Press the Up or Down button once to
i!_ _ display the setpoint temperature.
0_ Press either button more than once to
•change the setpoint.

Totaline Basic 1H/1C & 2H/1C
I:t'!'11I11_E@liil_
Your thermostat has a feature that helps prevent damage to the compressor of
your air conditioning or heat pump system. Because damage can occur if the
compressor is restarted too soon after shutdown, this feature forces the
compressor to wait 5 minutes before restarting. During the wait time, the message
Cool e or Heat _ flashes on the screen. When the safe wait time has elapsed,
the message stops flashing and the compressor turns on.

Operating Manual 570-207
NOTE: Batteries are optional (serving as backup power) only if your thermostat is connected to 24 VAC.
Set the System switch to Off before removing the batteries. Otherwise, the
heating/cooling system could remain activated even when batteries are
removed.
Install two fresh AAA batteries when the low-battery icon flashes
on the screen. The icon appears for 60 days before the batteries
are depleted.
Replace batteries once a year, or when you will be away for more
than a month.
The settings are stored in non-volatile (permanent) memory and
are thus preserved when the thermostat is without AC power or
batteries.
NOTE: The low-battery icon will not appear when the batteries are
depleted if the thermostat is connected to 24 VAC.

Totaline Basic 1H/1C & 2H/1C
II11[_,_ mi _rliil_,A
Screen is blank.
Temperature settings cannot be
changed.
Cool *_ or Heat # is flashing.
HI appears on the screen.
LO appears on the screen.
E1 appears on the screen.
E2 appears on the screen.
• Check circuit breaker and reset if necessary.
• Ensure the heating/cooling system is powered up.
• Ensure the furnace door is properly closed.
• Ensure two fresh AAA alkaline batteries are correctly installed,
• The System switch is off.
• You are setting the temperatures outside their allowable ranges:
• Heat: 40 °F to 90 °F (4.5 °C to 32 °C).
• Cool: 50 °F to 99 °F (10 °C to 37 °C).
• The compressor protection delay has been activated. Wait for the
delay to end (maximum of 5 minutes).
• The ambient (measured) temperature is above 122 °F (50 °C).
• The ambient (measured) temperature is below 32 °F (0 °C).
• The temperature sensor circuit is opened. Replace the thermostat.
• The temperature sensor circuit is shorted. Replace the thermostat.

Operating Manual 570-207
[ 111" _ _1 "
For assistance with this product, visit our website at www.totaline.com.
10

Totaline Basic 1H/1C & 2H/1C
TWO-YEAR WARRANTY -- This CARRIER CORPORATION product is warranted to be free from
defects in material and workmanship under normal use and maintenance for a period of two years from
date of original installation. A new or remanufactured part to replace the defective part will be provided
without charge for the part itself, through a qualified servicing CARRIER CORPORATION dealer or
service, PROVIDED the defective part is returned to our distributor. The replacement part assumes the
unused portion of the warranty.
THIS WARRANTY DOES NOT INCLUDE ANY ADDITIONAL LABOR ALLOWANCE OR OTHER
COSTS incurred for diagnosis, repairing, removing, installing, shipping, servicing or handling of either
defective parts or replacement parts. SUCH COSTS MAY BE COVERED BY a separate warranty
provided by the installer.
LIMITATIONS OF WARRANTIES -- ALL IMPLIED WARRANTIES (INCLUDING IMPLIED
WARRANTIES OF MERCHANTABILITY) ARE HEREBY LIMITED IN DURATION TO THE PERIOD FOR
WHICH THE LIMITED WARRANTY IS GIVEN. THE EXPRESSED WARRANTIES MADE IN THiS
WARRANTY ARE EXCLUSIVE AND MAY NOT BE ALTERED, ENLARGED, OR CHANGED BY ANY
DISTRIBUTOR, DEALER, OR OTHER PERSON WHATSOEVER.
CARRIER WILL NOT BE RESPONSIBLE FOR:
1. Normal maintenance as outlined in the installation and servicing instructions or owners manual.

Operating Manual 570-207
2. Damage or repairs required as a consequence of faulty installation or application by others.
3. Failure to start due to voltage conditions, blown fuses, open circuit breakers or other damages due to
the inadequacy or interruption of electrical service.
4. Damage or repairs needed as a consequence of any misapplication, abuse, improper servicing,
unauthorized alteration, or improper operations.
5. Damage as a result of floods, winds, fires, lightning, accidents, corrosive atmosphere, or other
conditions beyond the control of CARRIER CORPORATION.
6. Parts not supplied or designated by CARRIER CORPORATION.
7. CARRIER CORPORATION products installed outside the continental U.S.A., Alaska, Hawaii and
Canada.
8. Electricity or fue! costs or increases in electricity or fuel costs from any reason whatsoever including
additional or unusual use of supplemental heat.
9. ANY SPECIAL INDIRECT OR CONSEQUENTIAL PROPERTY OR COMMERCIAL DAMAGE OF ANY
NATURE WHATSOEVER. Some states do not allow the exclusion of incidental or consequential
damages, so the above limitation may not apply to you.
Model No. Unit Seria! No.
Date of Installation Installed by
Name of Owner Address of Installation
12

Totaline Basic 1H/1C & 2H/1C
Le present mode d'emploi porte sur les modeles suivants :
P310-0110 : Pour systemes a 1 etage de chauffage /1 etage de refroidissement
P310-0210 : Pour thermopompes a 2 etages de chauffage /1 etage de refroidissement
(Retirer le thermostat de sa plaque murale pour trouver le num@o de module.)
MISE EN GARDE : RISQUE DE DOMMAGE MATERIEL
Pour eviter des dommages au compresseur, ne pas utiliser le mode l
Refroidissement Iorsque la temperature ext@ieure est inferieure a 10 °C (50 °F).
Veuillez lire le mode d'emploi et le conserver en lieu s_r.
® Marque de commerce enregistree aux Etats-Unis. Brevets en instance.

Mode d'emploi 570-207
Aper£:u
Caracteristiques du thermostat ............ 1
Coup d'ceil rapide sur les contrSles ...... 2
Coup d'ceil rapide sur I'affichage .......... 3
Programmation et fonctionnement
Selecteur du syst_me (Heat/Cool) ....... 4
Selecteur du ventilateur (Auto/On) ....... 5
Reglage de la temperature ................... 6
Protection du compresseur .................. 7
Annexes
Remplacement des piles ...................... 8
En cas de difficulte ............................... O
Service a la clientele .......................... 10
Garantie limitee de 2 ans .................... 11

Totaline Basic 1H/1C & 2H/1C
=1
Votre nouveau thermostat Totaline a et6 congu pour vous procurer de
nombreuses annees de service fiable et assurer ta regulation de la temperature
ambiante avec facilite, par simple bouton-poussoir.
Caract_ristiques
•Affichage retro6clair6 facile a tire
• Affiche la temperature ambiante (mesuree) en tout temps
• Une seule touche permet de voir la temperature de consigne
• Protection integr6e du compresseur

Mode d'emploi 570-207
I_cran
S'illumine pendant 12 secondes
quand on appuie sur un bouton
lr_! F_,/j_ _ii Boutons Haut/Bas
//;-:: :_ Reglage de la temperature
/,
iii .... Bouton-s_lecteur du syst_me (voir la page 4)
ii • Cool : Le systeme est en mode Refroidissement.
• Off : Le systeme est arr&t6.
• Heat : Le systeme est en mode Chauffage.
• Em Heat :Le systeme est en mode Chauffage d'urgence.
Bouton-selecteur du ventilateur (voir la page 5)
• On : Le ventilatear marche sans arr_t.
• Auto : Le ventilateur marche uniquement Iorsque
le chauffage ou le refroidiseement eet active.

Totaline Basic 1H/1C & 2H/1C
Avertissement de piles faibles
(voir la page 8)
I_tat du syst_me
•Cool @ : Le refroidissement est active. *
• Heat _ : Le chauffage est active. *
•Stg2 : Le chauffage d'appoint est activ6. **
indication de la consigne
ApparaTt !orsque la temperature
de consigne est affichee. Temperature
La temperature ambiante
(mesuree) est normalement
affichee. Pour voir la
temperature de consigne,
appuyer une fois sur Fun
des boutons de reglage de
la temperature. La
temperature de consigne
apparaTtra pendant 5
secondes.
* Lorsque Cool @ ou Heat 8 clignote, la protection du compresseur est activee (voir la page 7).
** S'applique au mod_le P310-0210 uniquement.