Totally Wicked ARC PICO BABY User manual

USER MANUAL

3
Power button
LED light USB port
Mouthpiece
Tank
Tank base
Magnetic
connector
TOTALLY WICKED
ARC PICO BABY
ELECTRONIC
CIGARETTE KIT.
CONGRATULATIONS
ON PURCHASING YOUR
THE TOTALLY WICKED ARC PICO BABY

4 5
PRIMING THE ATOMIZER HEAD PRIMING THE ATOMIZER HEAD
Note: It is important to “prime” a new
atomizer head before first use. Failure
to do so can cause the atomizer coil to
overheat, leading to an unpleasant taste
and sometimes irreversible damage to
the atomizer head.
Remove the CS Air Baby tank from the
arc Pico Baby by pulling straight out, and
unscrew the magnetic connector from the
tank base. Invert the CS Air Baby tank
and unscrew the base. Drip a few drops of
e-liquid on each of the four e-liquid inlets
on the side of the atomizer head, and into
its central hole to fully wet the wicking
material.
Note: After priming a new atomizer head
and filling the tank, it is recommended
to wait 5 minutes to ensure the atomizer
head is fully saturated.

6 7
FILLING THE TANK
With the tank base removed and
the tank inverted, fill the CS Air
Baby tank through one of the
openings either side of the central
air hole, to a maximum level of just
below the height of the central air
hole. Avoid allowing liquid into the
central air hole. Once filled, screw
the base back onto the tank, screw
the magnetic connector back onto
the tank base, and slide the tank
back into the arc Pico Baby body.
Power On and Off
The switch lock needs to be fully disengaged to switch the arc Pico Baby on or
off. To do this, turn the power button outer ring anti-clockwise until at its highest
position. Press the power button 5 times quickly to turn the arc Pico Baby on. To
turn the device off, press the power button 5 times. Turn the power button outer
ring fully clockwise to engage the switch lock.
USING YOUR ARC PICO BABY

8 9
USING YOUR ARC PICO BABY
Vaping
Press and hold the power button as you
inhale the vapour. The LED will illuminate
while the power button is held down to
vape.
Battery level indication
Approximately one second after the power
button is released, the LED will relight to
show the battery’s approximate remaining
charge as detailed in the table opposite.
Charging the battery
To charge the battery, connect
the charge lead into the USB
port. The LED on the side of
the arc Pico Baby will glow
red and simultaneously flash 5
times in white when the charge
lead is first connected. Once
charging, the LED will continue
to glow red until fully charged,
at which point it will turn off.
Adjustment of airflow
To adjust the airflow to your
personal preference, remove
the CS Air Baby tank from the
device and turn the adjustment
ring. The more area exposed
behind the slots in the airflow
ring, the more open the air
draw will be.
USING YOUR ARC PICO BABY
Battery Level Light Condition
100%-60% Stays lit for 5 seconds
59%-30% Flashes once every
3 seconds, 4 times
29%-10% Flashes once every
1 second, 4 times
9-0% Flashes rapidly 4 times

10 11
CHANGING THE ATOMIZER HEAD
To change the atomizer head in
the CS Air Baby tank, unscrew the
magnetic connector from the tank
base. Invert the tank and unscrew
the base. Remove the atomizer
head from the base by unscrewing,
and insert a new atomizer head.
After fitting a new atomizer head,
remember that it will need priming
as described in the section “Priming
the Atomizer Head”
Short Circuit Protection
If a short circuit occurs before the power
button is pressed, the LED will flash 5 times
consecutively. If a short circuit occurs while
the power button is pressed, the LED will
flash 3 times consecutively. Replacing
the atomizer head should allow normal
operation to resume. Follow the steps
outlined in Changing the Atomizer Head.
Atomizer Protection
If the power button is held down for longer
than 15 seconds, the device will stop
producing any vapour and the power LED
will flash 10 times. After releasing the
power button normal operation will resume.
Low Voltage Protection
If the battery voltage drops below 3.3V, the
LED will flash 20 times and the device will
power off. Charge the device via USB to
power it back on.
USING YOUR ARC PICO BABY

12 13
KIT CONTENTS SPECIFICATIONS
1 x arc Pico Baby
1 x CS Air Baby tank
1 x CS 1.5ohm atomizer head (fitted)
1 x CS 0.75ohm atomizer head (spare)
1 x Magnetic connector
1 x USB cable
1 x User manual
1 x Spare parts kit
Dimensions: 41mm x 23mm x 75mm
Battery capacity: 1050mAh
Tank capacity: 2ml
Voltage Output: 3.3V - 4.2V (Direct)
Battery Voltage: 3.7V (Nominal)
Tank diameter: 16.5mm
Atomizer Resistance Capability:
0.4ohm - 3.0ohm
Power Output: Atomizer head resistance
dependent, maximum 25 watts
Maximum Filling Nozzle Diameter:
3.8mm
• Store the arc Pico Baby and its accessories away from children when not in use.
• Ensure the arc Pico Baby is powered off when not in use.
• Avoid accidentally pressing the arc Pico Baby power button when not in use.
• Please only use the charging cable provided.
• Please dispose of dead batteries in accordance with your country’s appropriate legislation.
• Do not charge the batteries in a damp environment.
• Do not use the device when temperatures are outside the range -10 - 60°0C.
• Do not charge the battery when temperatures are outside the range 0 - 45°C.
• Do not attempt to repair a faulty arc Pico Baby as these are sealed units with no
serviceable parts. Attempted repairs will void the warranty.
PRODUCT STORAGE AND BATTERY PRECAUTIONS

14 15
The arc Pico Baby components have a
28-day parts warranty, with the exception
of Atomizer Heads, which are consumable
items and covered by “dead on arrival”
warranty only. The USB cable supplied has
a 12-month warranty. If any parts are found
to be faulty within this time please contact
our customer service team, whose details
are on the back page of this booklet and
we will arrange for a replacement. We may
require the goods to be returned for further
investigation.
Additional product information
There are no reported medical side effects
with this product. If you believe you
experience a side effect, please contact the
manufacturer.
WARRANTY

Manufactured in China
under the authority
of Pillbox38 UK Ltd,
Stancliffe Street,
Blackburn, Lancashire,
BB2 2QR.
Tel [phone]
www.totallywicked.co.uk
Tel [phone]
www.totallywicked.com
Tel [phone]
www.totallywicked.de