Totally Wicked PSYCHE User manual

USER MANUAL
ELECTRONIC CIGARETTE KIT

TOTALLY WICKED
PSYCHE
ELECTRONIC
CIGARETTE KIT
CONGRATULATIONS
ON PURCHASING YOUR

3
THE TOTALLY WICKED PSYCHE
POWER
BUTTON
DISPLAY
SCREEN
+ BUTTON
TANK
CONNECTION
- BUTTON
TOP CAP
MOUTHPIECE
AIRFLOW
CONTROL

4
TOP CAP
MOUTHPIECE
AIRFLOW
CONTROL RING
ATOMIZER HEAD TANK BASE
ACRYLIC SLEEVE
THE TOTALLY WICKED PSYCHE

5
If you are familiar with using e-cigarettes, follow the quick start guide below to be
vaping in minutes:
• Prime the atomizer head.
• Fill the tank.
• Switch the Psyche on (5 clicks of the power button).
• Set the Psyche to 15 watts.
• Press and hold the power button and inhale.
• Charge the battery (possibly not shipped with a full charge).
Detailed descriptions of these steps and more are given in the full user guide.
QUICK START GUIDE

6
Priming the Atomizer Head
Note: It is important to “prime” a new atomizer head before first use. Failure to
do so can cause the atomizer coil to overheat, leading to an unpleasant taste
and sometimes irreversible damage to the atomizer head.
Remove the Rialto tank from the Psyche by unscrewing. Invert the Rialto tank and
unscrew the base. Drip a few drops of e-liquid on each of the four e-liquid inlets
on the sides of the atomizer head, and into its central hole to fully wet the wicking
material.
USING YOUR PSYCHE

7
USING YOUR PSYCHE

8
Filling the tank
Lift up the top section of the tank up and slide in the direction indicated by the arrow.
Insert the e-liquid filling nozzle into the fill hole and fill the tank, being careful to leave
an air gap of approximately 2mm. Slide the top of the tank back into place until there
is an audible click as it drops back into its original position.
Note: After priming a new atomizer head and filling the tank, it is recommended
to wait 5 minutes to ensure the atomizer head is fully saturated with e-liquid.
USING YOUR PSYCHE

9
USING YOUR PSYCHE

10
Power on and off
Press the power button 5 times in quick
succession to turn the Psyche on. To
turn the device off, again press the
power button 5 times repeatedly.
Vaping
Press and hold the power button as you
inhale the vapour. A puff timer will be
displayed on screen.
Charging the battery
To charge the battery, connect the
supplied charge lead into a suitable
USB connection port, the battery icon
on screen will begin to flash with a bolt
icon until fully charged.
USING YOUR PSYCHE
CHARGING PORT

11
Changing the atomizer head
To change the atomizer head in the Rialto tank, remove the Rialto tank from the
Psyche by unscrewing. Unscrew the base of the tank. Remove the atomizer head
from the base by unscrewing, and insert a new atomizer head. After fitting a new
atomizer head, remember that it will need priming as described in the section
“Priming the Atomizer Head”.
USING YOUR PSYCHE

12
Adjustment of airflow:
To adjust the airflow to your personal
preference, rotate the airflow control
ring located at the bottom of the tank.
The more area exposed behind the
slots in the airflow ring, the more
open the air draw will be.
USING YOUR PSYCHE

13
Setting the wattage:
The Psyche has adjustable wattage
that can be set from 1 – 80 watts. Use
the adjustment buttons to increase
or decrease the wattage on the
battery. The fitted atomizer head can
be used from 15 to 30 watts. For the
best balance of flavour and vapour
production we suggest a starting point
of 15 watts, which you can then adjust
in small increments to find your favourite
setting.
Wattage adjustment lock:
The Psyche’s wattage adjustment can
be locked to prevent the wattage from
accidentally being altered during use.
While the Psyche is powered on, press
the up and down adjustment buttons
simultaneously for 3 seconds. The
screen will display “Lock”. Repeating
this process will return the device to
normal operation, and the screen will
display “UnLock”.
USING YOUR PSYCHE

14
Rotating the display:
Pressing the up and down buttons simultaneously for 3 seconds when the Psyche is
powered off will rotate the screen display through 180°. This can be helpful if you are
left-handed.
Short circuit protection
If a short circuit occurs whilst the power button is pressed, the screen will display
“ATOMIZER SHORT”. Replacing the atomizer head should allow normal operation to
resume. Follow the steps outlined in “Changing the Atomizer Head”.
Atomizer protection
If the power button is held down for longer than 10 seconds, the device will stop
USING YOUR PSYCHE

15
producing any vapour. A message will appear on screen stating “Over 10s” and the
device will power off. 5 clicks of the power button will turn the device back on
and allow normal operation to resume.
Note: It is possible to change the maximum vaping time between 5, 10 and 15
seconds, or to turn this function off entirely. See “Advanced Functions” for more
information.
Dry Burn Protection
The Psyche features automatic Dry Burn Protection (DBP) technology, which
prevents atomizer heads from prematurely burning when the e-liquid level is low.
This technology is only active with the ML-S 0.6ohm atomizer head.
USING YOUR PSYCHE

16
ADVANCED FUNCTIONSADVANCED FUNCTIONS
5S 10S 15S Off
BATTERY VOLTAGE
VERSION
VAPING TIMEOUT
RETURN DISPLAY STEALTH PREHEAT

17
The Psyche has a number of advanced functions that can be activated, adjusted
or turned off entirely. They are functions that you do not necessarily need, and are
consequently held in a hidden menu. If you are not the sort of person that wants to
worry about this sort of detail, you can ignore them and use the standard factory
settings. However, if you are the sort of person that wants to fully customise your
vaping experience, read on!
To enter the advanced function menu press the power button and the up button
simultaneously for 3 seconds. You can then use the up and down buttons to scroll
along the display and access each function. The first function shown is the Return
symbol. Pressing the power button with this symbol highlighted, or simply waiting 10
seconds while taking no action, will exit the menu and return the Psyche to normal
operation.
ADVANCED FUNCTIONS

18
Display information:
The Psyche can display a choice of a puff counter, total vaping time or voltage output
beneath the atomizer resistance reading. Use the up and down buttons to select
the Display icon, then press the power button. You can then use the up and down
buttons to choose your preferred display information, and select it by pressing the
power button. Should you wish to reset the puff counter or the total vaping time,
pressing the up button for 3 seconds will set the selected counter to zero. Pressing
the power button will return the Psyche to the advanced menu.
ADVANCED FUNCTIONS

19
Stealth mode:
The Psyche is equipped with provision for “stealth mode”, where normal use will not
activate the screen, but a short press of the power button will allow the display to
function normally. Pressing the power button when the Stealth icon is highlighted
allows stealth mode to be turned on or off, using up and down buttons to highlight,
and power button to select.
ADVANCED FUNCTIONS

20
Preheat
The Psyche’s preheat function allows the atomizer head to heat up quickly by
providing additional power for a short period as the power button is pressed. To set
the preheat, access the menu by holding the up adjustment button and power button
simultaneously. Pressing the power button when the Preheat icon is highlighted
allows you to choose your preferred pre-heat power (Pwr) and heating duration
(Dura) up to 2 seconds. Use these setting cautiously, as preheat power much higher
than you are normally using can cause damage to your atomizer head. Setting the
preheat duration to zero (this is the default setting) disables the preheat function.
Preheat power is initially set at 30W.
ADVANCED FUNCTIONS