Toto UNIFIT ROUGH-IN Service manual

UNIFIT ROUGH-IN
INSTALLATION INSTRUCTION
Rev. 10/17
0GU185
PEOPLE-FIRST INNOVATION™
P: 888-295-8134
F: 770-282-8701
MATERIALS REQUIRED:
1. Mounting bolts
2. Wax ring/seal
TOOLS NEEDED:
1. Tape measure
2. Screwdriver
3. Putty knife
4.
Power drill, ⁄”drill bit (for
woo d floor installation) & ⁄ ”
masonry drill bit
(for
masonry/tile floor installation)
- for mounting block
5. Pencil
PACKAGE CONTENTS:
1. Rough-In - 1
2. Mounting screw w/washer - 2
3. Anchor - 2
4. Installation template - 1
5. Installation instruction - 1 “RI”
12 inch
10 inch
14 inch
TSU08W.12
(supplied)
TSU08W.10
(optional - must be purchased separately)
TSU08W.14
(optional - must be purchased separately)
Rough-In Part Number
6 "
4"
8"
STEP 1 PIPING CHECK AND ROUGH-IN
1. In order for your new TOTO toilet to fit correctly, check the
dimensions in the Table below. Rough-In (“RI”): Distance between
finished wall to the center of the toilet outlet.
2. Remove existing toilet (if necessary)
Please make sure that you have the correct outlet connection part.
1155 Southern Road
Morrow, GA 30260
totousa.com |
STEP 2 INSTALLING MOUNTING BOLTS
1. Cover/block the drain opening to prevent items from falling into the drain and prevent smell from
coming up.
2. Clean any debris out of the closet flange.
3. Install the mounting bolts (either provided by the original closet flange or new wax ring) into the slots
of the flange. Insert the bolts into the slot with its head down and threaded shank pointed upward.
PAGE 1 of 2
Centerline of stop valve
Finished wall
4¾”
(120mm)
Centerline of ange
4¾”
(120mm)
3½” (90mm) M
AX
“RI”

Rev. 10/17
0GU185
PEOPLE-FIRST INNOVATION™
P: 888-295-8134
F: 770-282-8701
STEP 3 INSTALLATION TEMPLATE INSTRUCTION
Follow the Installation Template instruction that comes
with the Installation Template.
1155 Southern Road
Morrow, GA 30260
totousa.com | PAGE 2 of 2
STEP 4 INSTALLING THE ROUGH-IN
1. Flip the rough-in upside down and firmly press a new
wax seal onto the circular recess around the
outlet opening.
2. Turn the rough-in upright and lower it into position
over closet flange. With the unit properly aligned, press
down firmly to set wax seal.
NOTICE: DO NOT move the outlet connection after
the wax seal is set. If this notice is disregarded, you
will have to discard the wax seal and replace with a
new one.
3. Insert washers and thread nuts onto mounting bolts on
the closet flange and hand tighten. Then tighten bolts
an additional ½turn.
4. Secure back side of the rough-in to the floor using the
2 screws provided by the rough-in.
5. Make sure to secure the two mounting blocks to
the floor.
Screw
Washer
Nut
Wax seal