6
Before First Use:
Read all instructions and safety information
carefully before first use. Please retain this
information for future reference.
1. Remove the appliance from the
packaging and check for any visible signs
of damage to the unit and cable.
2. Assemble as instructed.
3. Your appliance is now ready for normal
use.
4. Dispose of the packaging in a responsible
manner.
5. Place the unit on a firm and level surface.
Assembly of your desk fan:
1. Remove the 4 grille locking screws from
the main body.
2. Set the rear grille in the proper position
with the handle up. Let the four screws
go through the rear guard hole and
tighten (but do not over tighten).
3. Discard the plastic sleeve on the shaft.
Install the blade onto the shaft until the
retaining pin fits into the notch on the
blade, then use the screw to fix it and
tighten (but do not over tighten).
4. Mount the Front Safety Grille onto the
Rear Grille by hanging the top hook clip
of the front guard over the top of the
Rear Grille. Close the clasps all around
the grille, then secure it with the locking
screw and nut.
Note: When first inserting the locking screw
into the corresponding holes on the rim of the
fan grille, only tighten it loosely. Ensure you
have secured the front safety grille as detailed
above before tightening this screw in all the
way; otherwise, the front safety grille may not
be correctly installed.
Adjustable tilting head:
Use the top two screws to adjust the angle of
the fan head.
Loosen the screws to move the head to the
desired angle, and tighten them to lock into
place.
CAUTION! Do not use the fan when the front
guard is not locked into place.
Note: Make sure that the fan is on a level
surface and away from any liquids.
Oscillating the fan will create a more uniform
cooling effect in the room.
