6
Before First Use:
Read all instructions and safety information
carefully before first use. Please retain this
information for future reference.
1. Remove the appliance from the
packaging and check for any visible signs
of damage to the unit and cable.
2. Your appliance is now ready for normal
use.
3. Dispose of the packaging in a responsible
manner.
4. Place the unit on a firm and level surface.
Using your appliance:
1. Place the fan in the desired location.
Ensure the fan is placed in a dry and level
surface. Please note this fan is designed
for floor use.
2. Plug the fan into an electrical wall outlet.
Make sure all of the buttons at the back
are DE-PRESSED before plugging in your
fan.
3. Loosen the nut on the left hand side
of the fan by turning it anti-clockwise,
and manually adjust the direction of
the airflow and the angle of the fan as
desired. Take care not to tilt the fan at an
angle higher than 100 degrees, as doing
so will damage the unit. Once you have
selected your ideal ventilation angle,
tighten the nut again by rotating it in a
clockwise direction.
4. Press the relevant speed button at the
back to select the required fan speed:
0 Stop
I Slow
II Medium
III High
Cleaning and care:
Before cleaning always switch off the appliance
and remove the plug from the electrical
socket.
To clean the outside of the fan, wipe the
exterior with a soft, damp cloth.
Never use an abrasive cleaner.
When not in use, store the fan (preferably in its
original box) in a cool, clean and dry location.
Cleaning the fan blades:
Remove the front guard by unclipping the
locking clips located around the circumference
of the guard. The top lock does not unclip.
Use a small spanner to unscrew the nut and
bolt that holds the bottom of the front guard
to the back guard.
WARNING:
DO NOT immerse any electrical part of
the appliance in water such as motor units
or plugs.
Please see cleaning section for further
instructions.
