
8
1. Remove the parts from the packaging.
2. Place the processor on a flat, dry surface.
3. Remove any promotional labels or stickers.
4. Assemble the appliance.
5. Your appliance is now ready for normal use.
WARNING: The product may emit a small amount of smoke when it is first turned
on. This is due to manufacturing oils and/or residue left on the motor. There is no
need for alarm and is considered normal. The smoke will eventually lessen once
the oil and/or residue disappears.
1. Fit the drive shaft onto the power unit
2. Then fit the bowl. Place the handle towards the back and turn anticlockwise
until it locks
3. Fit your desired attachment over the drive shaft. Always fit the bowl and
attachment onto the machine before adding ingredients.
4. Fit the lid, ensuring the top of the drive shaft locates into the centre of the lid.
5. Do not use the lid as a means to operate the processor; always use the ON/OFF
control.
6. Switch on and select a speed.
NOTE: The processor won’t work if the bowl and lid are fitted incorrectly.
Use the pulse (p) for short bursts. The pulse will operate for as long as the control
is held in position.
Reverse the above procedure to remove the lid, attachments and bowl.
Always switch the unit off before removing the lid.
IMPORTANT: Your processor is not suitable for crushing or grinding coffee beans,
or converting granulated sugar to caster sugar.
NOTE: Additives such as almond essence, colourings and other flavourings may
cause discolouration to the bowl, jug and or lids
1. Fit the sealing ring into the blade unit ensuring the seal is located correctly.
2. Leaking will occur if the seal is damaged or not fitted correctly.
3. Screw the jug onto the blade unit.
4. Put your ingredients into the jug
5. Put the blending cap onto the lid, then turn.
6. Turn the lid in an anticlockwise direction to lock onto the jug. Always check
that this is secure.
7. Place the liquidiser unit onto the power unit and turn to lock. Always check
that this is secure.
8. Select a speed or use the pulse control.
9. Allow all liquids to cool to room temperature before placing them in the
liquidiser.
4 - Before First Use
5 - Using Your Appliance