TowMate TM3N User manual

TowMate, LLC. : 15827 Serenity Point Ln. : Rogers, AR 72756 : Phone [phone] : Fax [phone]
“TM3N”
TowMate Light-Duty Wireless Towlight Guide to Operations
Thank you for purchasing a TowMate Wireless Tow Light!
System Features:
Your complete system should include:
oThe Lights, Transmitter (the sending unit that plugs into the truck), and a Double-
Ended Cigarette Lighter Charge Cord (DC charger).
High performance electronics provide optimum range and reliability.
o1,000 feet of ‘line-of-sight’ range.
oInjection molding keeps the electronics completely sealed from the elements
such as moisture, corrosion, or vibration damage.
Lifetime Warranty
oCovers Electronics and LED’s
If ever the light fails to get a signal or an LED burns out, TowMate will
replace the defective component at no cost.
I-MON Compatible
oNever leave your light behind again with the new I-MON Interactive Monitoring
System available now! (TM22G is not compatible)

TowMate, LLC. : 15827 Serenity Point Ln. : Rogers, AR 72756 : Phone [phone] : Fax [phone]
General Operating Tips:
THESE UNITS MUST BE CHARGED FOR AT LEAST 4 HOURS BEFORE USING
1. First, plug the transmitter into the receptacle on the truck.
2. Power the light on by pressing the side marker light in.
3. The Light should now be fully operational for Wireless S/T/T signals.
4. Use the 12VDC power cord provided to recharge the unit.
a. It takes 6-8 hours to fully recharge the battery in the light.
b. You cannot overcharge the unit off of the trucks 12V system.
c. DO NOT PLUG IN TO CHARGE CORD IF BATTERIES ARE REPLACED WITH
ANYTHING OTHER THAN NiCad (Nickel Cadmium) or NiMH (Nickel Metal
Hydride) RECHARGEABLE BATTERIES.
d. You can use standard AA batteries as a replacement if your batteries are dead or
will not recharge, just do not plug the units in to the charge cord.
5. Always check to be sure that the light is securely fastened to the load you are hauling and
that the magnets are clean of debris.
a. USE CAUTION WHEN SECURING TO THE VEHICLE. EACH MAGNET IS 100-LB.
PULL, KEEP YOUR FINGERS CLEAR IN ORDER TO AVOID INJURY.
4-Pin Wiring
** This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.