TP-Link Omada FC311B-20 User manual

Gigabit WDM Media Converter
Enlarge Your Ethernet Network
©2023 TP-Link 7106510664 REV2.20.0
LED Explanation
On: Power on
O:
Power o
PWR
On: Valid link
Flashing: Transmitting or receiving data
O: Invalid link
Scenario 1: Connect Devices with and without Optical Interfaces
LC-SC Fiber Cable
Ethernet Device
with Optical Interfaces
Twisted-Pair Cable
Ethernet Device
without Optical Interfaces
Media Converter
Gigabit Ethernet
1000BASE-X (Fiber) Interface
Gigabit Ethernet
PWR
Link/Act
Package Contents: Converter, Power Adapter, Installation Guide

EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU,
2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce.
Safety Information
• Keep the device away from water, re, humidity or hot environments.
• Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
• Do not use damaged charger or USB cable to charge the device.
• Do not use any other chargers than those recommended.
• Adapter shall be installed near the equipment and shall be easily accessible.
• Do not point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can injure your eyesight
• Use only power supplies which are provided by manufacturer and in the original packing of this product. If you have any questions, please don't
hesitate to contact us.
Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due
to improper use of the device. Please use this product with care and operate at your own risk.
Note: Please use one TL-FC311A-2 and one TL-FC311B-2 together to work properly.
Please use one TL-FC311A-20 and one TL-FC311B-20 together to work properly.
Scenario 2: Connect Devices without Optical Interfaces
SC-SC Fiber CableTwisted-Pair Cable Twisted-Pair Cable
Ethernet Device
without Optical Interfaces
Media Converter Media Converter Ethernet Device
without optical Interfaces
Gigabit Ethernet
Gigabit Ethernet
General Specifications
Specications
Environmental and Physical Specifications
0˚C to 50˚C (32˚F to 122˚F)
-40˚C to 70˚C (-40˚F to 158˚F)
5% to 90% RH non-condensing
10% to 90% RH non-condensing
Operating Temperature
Storage Temperature
Storage Humidity
Operating Humidity
IEEE 802.3, IEEE 802.3i, IEEE 802.3u,
IEEE 802.3ab, IEEE 802.3x, IEEE 802.3z
Standards
1 SC ber optic; 1 RJ45 jackConnector
Twisted-Pair 100BASE-Tx: 2-pair UTP/STP of Cat. 5 or above (≤100 m)
1000BASE-Tx: 4-pair UTP/STP of Cat. 5e or above (≤100 m)
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
To ask questions, find answers, and communicate with TP-Link users or
engineers, please visit https://community.tp-link.com to join TP-Link
Community.
PWR
PWR
PWR, Link/ActLED
External Power Adapter: 5 V/0.6 APower
FC311A-2/FC311A-20: 1550 nm Tx, 1310 nm Rx
FC311B-2/FC311B-20: 1310 nm Tx 1550 nm Rx
Wave Length
Dimensions 94.5x73x27 mm
Transmission
Distance
FC311A-2/FC311B-2: ≤2 km
FC311A-20/FC311B-20: ≤20 km
Gigabit Ethernet Gigabit Ethernet
Fiber 9/125 μm single-mode ber
UK declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of the Electromagnetic
Compatibility Regulations 2016 and Electrical Equipment (Safety) Regulations 2016.
The original UK declaration of conformity may be found at https://www.tp-link.com/support/ukca/
CAN ICES-3 (A)/NMB-3(A)
Industry Canada Statement
FCC compliance information statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Product Name: Gigabit WDM Media Converter
Model Number: FC311A-2/FC311B-2/FC311A-20/FC311B-20
Responsible party:
TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: https://www.tp-link.com/us/
Tel: [phone]
Fax: [phone]
E-mail: [email protected]
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with
the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and
the equipment is properly maintained and operated.
Issue Date: 2023/12/26
This is a class A product. In a domestic environment, this product may cause radio interference, in which case the
user may be required to take adequate measures.
CE Mark Warning
E
xplana�on of the symbols on the product label
S
ymbols may vary from products. The label is at the bottom of the product.
Symbol
Explanation
Cla ss II equipment
Cla ss II equipment with functional earthing
Alternating current
Direct current
Pol arity of d.c. power connector
For indoor use only
Dangerous voltage
Caution, risk of electric shock
Ene rgy e ciency Ma rking
Protective earth
Earth
Frame or chassis
Functional earthing
Caution, hot surface
Caution
Operator's manual
Stand-by
"ON"/"OFF" (push-push)
Fuse
Fuse is used in neutral N
Caution, avoid listening at high vol ume l evels for long periods
Dis connection, allpower plugs
m Switch of mini-gap construction
µ
Switch of micro- gap construction (for US version)
Switch of micro-gap /micro - disconnection construction
(for other versions except US)
ε Switch without contact gap (Semiconductor switching device)
RECYCLING
This product bears the selective sorting symbol for Waste
electrical and electronic equipment (WEEE). This means that
this product must be handled pursuant to European directive
2012/19/EU in order to be recycled or dismantled to minimize its
impact on the environment.
User has the choice to give his product to a competent recycling
organization or to the retailer when he buys a new electrical or
electronic equipment.
Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних
документів та вимогам, що передбачені чинними законодавчими актами України.