TPG Netgear Nighthawk D7800 User manual

1
Modem Setup Guide –NBN FTTP
Netgear Nighthawk D7800
Please follow the steps below to set up your Netgear Nighthawk D7800.
1. Ensure your NBN Connection Box is turned on.
2. Plug an Ethernet cable from the UNI-D1 port on your NBN Connection Box into the red
Internet port on your Nighthawk modem.
If UNI-D1 doesn’t work, try each UNI-D port.
3. Plug in the power cable and turn your Nighthawk modem on using the Power button.
4. You can connect devices such as PC desktops, laptops or gaming consoles by plugging
Ethernet cables from the device to any of the four yellow LAN ports, or you can connect
devices via WiFi.
5. Go to http://192.168.0.1 or http://www.routerlogin.net in your browser.

2
Modem Setup Guide –NBN FTTP
6. Log in with your Netgear modem username and password.
By default, these are:
Username: admin
Password: password
7. On the home screen, click Advanced.
8. Click Setup.
9. Click WAN Setup.
10. Select Must use Ethernet WAN from the WAN Preference drop-down.
11. Click Apply.
12. Click Basic.
13. Click Internet.
14. Select Australia from the Country drop-down.
15. Select TPG from the ISP drop-down.
16. Click Yes under Does your Internet connection require a login?
17. Select PPPoE (PPP over Ethernet) from the Encapsulation drop-down.
18. Enter your TPG username and password.
19. Leave the other settings as they are and click Apply.
Once you receive notification that your TPG NBN service is active, your Nighthawk D7800
should now be online. If you are still having issues, please call us on 1300 997 271 for
further assistance.