TPG Netgear Nighthawk RAX120 User manual

1
Modem Setup Guide –NBN FTTP
Netgear Nighthawk RAX120
Please follow the steps below to set up your Netgear Nighthawk RAX120.
1. Ensure your NBN Connection Box is turned on.
2. Plug an Ethernet cable from the UNI-D1 port on your NBN Connection Box into
the Internet/WAN port on your Nighthawk modem.
If UNI-D1 doen’t work, try each UNI-D port.
3. Plug in the power cable and turn your Nighthawk modem on using the Power button.
4. You can connect devices such as PC desktops, laptops or gaming consoles by plugging
Ethernet cables from the device to any of the four LAN ports, or you can connect
devices via WiFi.
5. Go to http://192.168.1 or http://www.routerlogin.net in your browser.

2
Modem Setup Guide –NBN FTTP
6. Log in with your Netgear modem username and password.
By default, these are:
Username: admin
Password: password
7. Select Internet Port for WAN Preference.
8. Select PPPoE (PPP over Ethernet) from the Encapsulation drop-down.
9. Enter in your TPG username and password.
10. Click Apply.
Once you receive notification that your TPG NBN service is active, your Nighthawk RX120
should now be online. If you are still having issues, please call us on 1300 997 271 for
further assistance.