TPG VR600v User manual

1
Modem Configuration Guide
VR1600v (NBN FTTN & NBN FTTB)
Mac OS X
IMPORTANT MESSAGE
Your modem has already been pre-configured, you do not need to follow each step of the set-up guide but should retain
this document in case you need to manually configure your equipment.
To configure your PC/Laptop with your wireless password including changing your wireless password, please
proceed to step 3.
Contents
1. Physical Connection
2. Configuring Modem
3. Configuring Wireless
4. Change of Password
1. PHYSICAL CONNECTION
Have your modem powered on and connected directly to your PC via Ethernet Cable before you begin, as these
instructions are based on wired Ethernet connection
For further information, please see wiring diagram and instructions for your NBN connection type below.
• NBN Fibre To The Node (FTTN)
• NBN Fibre To The Building (FTTB)
VR1600v

2
Modem Configuration Guide VR1600v
E. Click the Edit button on pppoe_ptm_2_0_d.
D. On the menu on the left side of the page, click
Network to expand the menu and then
click DSL.
C. You will see the home screen shown on the right.
Click the Advanced tab.
2. CONFIGURING MODEM
A. Open your browser and in the address bar type
http://192.168.1.1 and press Enter
B. Enter admin for both the username and password and click Login.
If you have changed the login credentials, please enter the current
username and password for your modem interface.

3
Modem Configuration Guide VR1600v
I. You can change your Wi-Fi details or keep
the default settings. The default Wi-Fi SSID
(network name) is WiFi-xxxx (xxxx is a random
4 digit alphanumeric code printed on the sticker
underneath your modem). By default, the Wi-Fi
password is printed on a sticker underneath your
modem (Wireless Password/Key). Click Save.
Setup complete!
H. On the menu on the left side of the page, click
Wireless.
G. Click the Basic tab.
F. Enter your TPG Username and Password.
Click Save

4
Modem Configuration Guide VR1600v
3. CONFIGURING WIRELESS
A. Click on the Wi-Fi Icon at the top of your screen. A list of Wi-Fi networks will be displayed
B. Click on the name of your modem. By the default, the
network name should be WiFi-xxxx (xxxx is a random 4 digit
alpha numeric code). This is written on a sticker on the
bottom of your modem
Note: You may notice there are two wireless networks
present. You may connect to either of these.
C. Enter your wireless password. By default this is the same
as your TPG account password.
D. Click Join.
E. You should now be connected to your modem
13 14 23tpg.com.au/support
4. CHANGE OF PASSWORD
For security purposes we highly recommend that you change your password if you are using your default or if you believe your
password security has been compromised. For password information, please visit www.tpg.com.au/support.
PLEASE NOTE:
Each time your modem is powered on, it will initialize this automated authentication process after which your modem will
receive a public dynamic IP address (fixed or dynamic depending on your plan) and DNS settings from TPG.
WiFi-2345
WiFi-3456
WiFi-Y659