
HEAD TORCH / WORK LIGHT
BATTERY TREATMENT / CHARGING
Charge time: 2.5hrs
Runtimes: 2hrs @ 260 lumens
4hrs @ 120 lumens
Battery specication:
3.7V 4400mAh Li-ion
OPERATION
Head Torch Mode
1. Place Xtra260 on head ensuring the buttons
are facing upwards and adjust the elasticated
strap for comfort.
2. Press the power button once to turn the light
to full brightness, also illuminating the green
led indicator light adjacent to the power
button. Press power button a second time
to dim the brightness to the lower brightness
level.
3. Toswitchopressthepowerbuttonathird
time. The green led indicator light adjacent
tothepowerbuttonwillalsoswitcho.Light
shows green for charged and red for low
battery.
Wave / Motion Sensor Mode
1. For ease of use, or simply if the user has oily
or dirty hands the Xtra260 has been design
with a none contact wave/motion sensor on
/oswitch.
2. To activate the wave motion sensor mode,
press the motion mode button. This will
trigger the illumination of the blue and green
Led indicator lights between the two control
buttons. This indicates the wave/sensor
mode is now active.
3. Passing / waving your hand within 3cm of the
light front will automatically toggle the light
from ON to OFF or OFF to ON. Movement
can be up and down or towards the light to
be detected by the sensors.
4. Toswitchothismodeeitherpressthepow-
er button activating the light on permanently,
or press the wave / motion button to switch
allmodeso.
Worklight Mode
1. An extremely useful feature of the Xtra260
is the work light mode. The front section
of the head torch can be easily removed
from the headband base to provide a
portable work light with magnetic base
and 360 degree swivelpositioning mount.
2. Rotate main light anti-clockwise on the
black mounting plate. This will release the
worklight from the head torch strap.
3. Click open base from light allowing light to
be positioned on 360 degree ball adapter
as required.
4. The base can be used as a stand on a lev-
elsurface,orusethemagneticbasetox
to any metallic surface allowing the light
to be used from multiple angles.
5. The worklight is switched ON and OFF in
the same way as the Head Torch mod
6. The worklight can easily be re-attached
to the head strap by locating the centre of
the base plate and rotating clockwise until
attached.
Charging
• Chargethebatteryfullybeforerstuse
• Rechargewhentheindicatorisashing
• Fullychargedwhenallindicatorsstopashing
• Do not leave the battery fully discharged