TradeTuff TUFF-T2000 User manual

0800 292 2188
tradetuff.co.uk [e-mail]
TUFF
-
T2000
HIGH POWERED 2K LUMEN
LED WORK LIGHT
Product Diagram
METABO
DEWALT
T2000 - 5-in-1 T2000 - 4-in-1
PANASONIC
MAKITA
HIKOKI
BOSCH
MILWAUKEE

0800 292 2188
tradetuff.co.uk [e-mail]
1OPERATING INSTRUCTIONS
Battery installation
1.1 Pull the “DE” up.
1.2 Press the buttons on both sides
to make sure “DE/MI” up.
1.3 Slide the battery into the adaptor.
1.1 Pull the “MI” up.
1.2 Press the buttons on both sides
to make sure “DE/MI” up.
1.3 Slide the battery into the adaptor.
Slide into
1.1 Pull the “ME” up.
1.2 Make sure “DE/MI” down.
1.3 Slide the battery into the adaptor.
DEWALT Battery(14.4V or 18V)
MILWAUKEE Battery(14.4V or 18V)
METABO, MAFELL, CAS Battery(14.4V or 18V)
Slide into
Slide into
T2000 - 5-in-1
T2000 - 4-in-1
1. Pull the “H” up.
2. Slide the battery into the adaptor.
1. Pull the “M” up.
2. Slide the battery into the adaptor.
1. Pull the “B” up.
2. Slide the battery into the adaptor.
1. Pull the “P” up.
2. Push the component “A” on both side.
3. Press the battery into the adaptor.
HIKOKI Battery(14.4V-18V)
MAKITA Battery(14.4V-18V)
BOSCH Battery(14.4V-18V)
PANASONIC Battery(14.4V-18V)
A

0800 292 2188
tradetuff.co.uk [e-mail]
Voltage Switch
18V
14.4V
14.4V 18V
Choose the right battery voltage
Press the switch to turn on the light
Red indicator is for 18V.
Green indicator is for 14.4V.
Adaptor has a memory for the battery voltage. That means
when switching to 14.4V, the default voltage memory will be at
14.4V.
18V Battery
Press Voltage Switch.
Please make sure the voltage indicator is red.
△
△
When the battery is inserted into the light. Red indicator on. 5S red indicator off.
18V
14.4V
14.4V Battery
Press Voltage Switch.
Please make sure the voltage indicator is green.
18V
14.4V

0800 292 2188
tradetuff.co.uk [e-mail]
Model NO.
Power
Lumens
RA 70
24W
Battery Tool battery(14.4V-18V)
2000lm
T2000
CCT 6500K
Working Mode 100%/50%/-25%
Operation Temp.
Storage Temp.
Charge: 0℃~4 5℃ Discharge: -10℃~4 5℃
0℃～4 0℃（Capacity 80%）Recommended long-term: 15℃~ 25℃
223 x 182 x 361mm
Item Size
IP 54
Beam Angle 90°
2PRODUCT SPECIFICATION
3SAFETY INSTRUCTIONS
3.1 SAFETY INFORMATION
• DO NOT use the worklight if you suspect it has been damaged.
• DO NOT cover the battery while charging.
• DO NOT cover or block the lense during use.
• DO NOT allow children to use the worklight.
• DO NOT use if the light is damaged.
• DO NOT tamper with the battery pack or wiring.
•The battery pack is protected against overcharging, deep discharging and over current.
•The battery pack should only be charged in an ambient temperature of 0 ℃to 45
• The work light should only be used in an ambient temperature of -10 ℃to 45 ℃.
3.2 MAINTENANCE
• DO NOT clean the work light with solvents.
• Store in a clean dry area when not in use.
• Check all cables etc. for damage before use.
3.3 Failure to follow instructions may result in product anomalies.