Trane 0411 Reference manual

General Service Bulletin
Odyssey with Symbio 700 Not Operating
Product Code: 0411, 0419, 1052, 1053, 5293
May 2021 SS-SVB022A-EN
Confidential and proprietary TraneTechnologiesinformation
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating,
and air-conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or
altered equipment by an unqualified person could result in death or serious injury. When working on the equipment, observe all
precautions in the literature and on the tags, stickers, and labels that are attached to the equipment.
SAFETY WARNING

Confidential and proprietary Trane Technologies information.
Distribute only to authorized agents.
SS-SVB022A-EN
© 2021
Introduction
Readthismanualthoroughlybeforeoperatingorservicing this unit.
Warnings, Cautions, and Notices
Safety advisories appear throughout this manual as required.
Yourpersonalsafetyandtheproperoperationof this machine
depend upon the strict observance of these precautions.
The three types of advisories are defined as follows:
Indicates a potentially hazardous situation
which, if not avoided, could result in death
or serious injury.
Indicates a potentially hazardous situation
which, if not avoided, could result in minor
or moderate injury. It could also be used to
alert against unsafe practices.
NOTICE Indicatesasituationthatcouldresultin
equipment or property-damage only
accidents.
Important Environmental Concerns
Scientific research has shown that certain man-made chemicals
can affect the earth’s naturally occurring stratospheric ozone
layer when released to the atmosphere. In particular, several of
the identified chemicalsthatmay affect the ozone layer are
refrigerants that contain Chlorine, Fluorine and Carbon (CFCs) and
those containing Hydrogen, Chlorine, Fluorine and Carbon
(HCFCs). Not all refrigerants containing these compounds have
the same potential impact to the environment.TraneTechnologies
advocatestheresponsiblehandlingof all refrigerants-including
industry replacements for CFCs and HCFCs such as saturated or
unsaturated HFCs and HCFCs.
Important Responsible Refrigerant Practices
Trane Technologies believes that responsible refrigerant practices
are important to the environment, our customers, and the air
conditioning industry. All technicians who handle refrigerants
must becertified according to local rules. For the USA, the Federal
CleanAir Act (Section608) setsforth therequirementsforhandling,
reclaiming,recoveringand recyclingof certain refrigerantsand the
equipment that is usedintheseserviceprocedures.Inaddition,
somestates or municipalities may have additional requirements
that must also be adhered to for responsible management of
refrigerants. Know the applicable laws and followthem.
Proper Field Wiring and Grounding
Required!
Failure to follow code could result in death or serious injury. All
field wiring MUST be performed by qualified personnel.
Improperly installed and grounded field wiring poses FIRE and
ELECTROCUTION hazards. To avoidthesehazards,youMUST
followrequirementsfor field wiring installation and grounding
as described in NEC and your local/state electrical codes.
WARNING
Personal Protective Equipment (PPE)
Required!
Failure to wear proper PPE for the job being undertaken could
result in death or serious injury. Technicians, in order to protect
themselves from potential electrical, mechanical, and chemical
hazards, MUST follow precautions in this manual and on the
tags, stickers, and labels, as well as the instructions below:
•
Before installing/servicing this unit, technicians MUST put
on all PPE required for the work being undertaken
(Examples;cut resistantgloves/sleeves, butyl gloves, safety
glasses, hard hat/bump cap, fall protection, electrical PPE
and arc flash clothing). ALWAYS refer to appropriate Safety
DataSheets(SDS)andOSHA guidelines for proper PPE.
•
When working with or around hazardous chemicals,
ALWAYS refer to the appropriate SDS and OSHA/GHS
(Global Harmonized System of ClassificationandLabelling
ofChemicals)guidelines for information on allowable
personal exposure levels, proper respiratory protection
and handling instructions.
•
Ifthereisariskof energizedelectricalcontact,arc,or flash,
techniciansMUSTput onallPPEinaccordance with OSHA,
NFPA 70E, or other country-specific requirements for arc
flash protection, PRIOR to servicing the unit. NEVER
PERFORM ANY SWITCHING, DISCONNECTING, OR VOLTAGE
TESTING WITHOUT PROPER ELECTRICAL PPE AND ARC
FLASH CLOTHING. ENSURE ELECTRICAL METERS AND
EQUIPMENT ARE PROPERLY RATED FOR INTENDED
VOLTAGE.
WARNING
WARNING
CAUTION

Confidential and proprietary Trane Technologies information.
Distribute only to authorized agents.
SS-SVB022-EN
3
Copyright
Thisdocumentandtheinformationinitarethepropertyof Trane
Technologies, and may not be used or reproduced in whole or in
part without written permission. Trane Technologies reserves the
right torevisethispublicationatanytime,andtomakechanges to
its content without obligation to notify any person of such
revision or change.
Trademarks
All trademarks referenced in this document are the trademarks of
their respective owners.
Revision History
A. Initial release
Description
The purpose of this service bulletin is to advise the field of an
issue with Symbio 700 on Odyssey split systems where the
equipment will not respond to commands or inputs.
Theactiondescribedinthisgeneralservicebulletin is NOT being
taken to address a safety concern.
This is an INFORMATION ONLY service bulletin.
Affected Units
Odyssey condensing unit Model TTA and TWA, with Symbio 700
(model digit 15 = S) and serial number range 2036* through
2116*.
Discussion
Odyssey split system equipment with Symbio 700 controllers and
firmware v1.00.018, v1.00.019 or v1.00.020 may become
unresponsive to commands and/or inputs, and the equipment will
not operate.
Field return analysis has detected that a population of Symbio 700
controllers were configured with an error from the factory.
Possible symptoms of this issue include:
•Controller is powered on, but equipment does not run
•Controller ignores thermostat inputs, but gives no indication
why
•Controller will have a configuration, but may be missing
points
•Onboard Display may be missing Settings and Status pages
The failure mode can be confirmed using the Symbio Service and
Installation App. The notice “The equipment will start.”, followed
by error “An unknown error occurred (code 00604:16)” is
confirmation. See Figure 1.
Figure 1: Symbio Service and Installation App error confirmation
Upon startup or during preventive maintenance, update firmware
to ensure proper operation over the life of the equipment.
Follow EHS Policies!
Failure to follow instructions below could result in death or
serious injury.
•
All Trane Technologies personnel must follow the
company’s Environmental, Health and Safety (EHS) policies
when performing work such as hot work, electrical, fall
protection, lockout/tagout, refrigerant handling, etc.
Where local regulations are more stringent than these
policies, those regulations supersede these policies.
•
Non-Trane Technologies personnel should always
follow local regulations.
WARNING

Confidential and proprietary Trane Technologies information.
Distribute only to authorized agents.
SS-SVB022-EN
3
4
5
4
Corrective Action
1. Reset configuration
a. Using a Bluetooth enabled mobile phone,
install/update the Symbio Service and Installation App
(v1.1.2 or greater) from the appropriate app store.
b. Connect Symbio 700 to the app
c. Go to “Tools” Page
d. Click “Restart Controller”
e. Select “Reset Configuration”. The user will receive one
of the two messages below.
Note: If the “Reset Configuration” button is not
available, your Symbio Service and Installation App
needs to be updated to the latest version. Refer to
Step 1.
•"No configuration issues found." This indicates
that the controller does not have the issue and
nothing was fixed. Selecting “OK” will close the
notification and return to the Symbio Service and
Installation App.
•"The configuration was reset. This process will
disconnect the app from the controller and you
will be redirected to the device list." This
message indicates that the controller has the
issue. Selecting “OK” will fix the issue and will
disconnect the user from the controller.
2. Verify Symbio 700 firmware (v1.00.022 or greater)
a. Identify the Symbio 700 version displayed on the user
interface or displayed on the Symbio Service and
Installation App
b. Compare the Symbio 700 version to the latest version
available at:
https://www.trane.com/commercial/north-
america/us/en/products-systems/packaged-units-and-
split-systems/split-systems/odyssey-6-to-25-
tons.html#downloads
c. Download the latest firmware to a USB mass storage
device formatted as FAT32
3. Update Symbio 700 firmware if not the latest, using Tracer
TU OR Symbio Service and Installation App:
a. Tracer TU - Update using the File Transfer utility
b. (Recommended) Symbio Service and Installation App:
•Install the USB mass storage device into the USB
host connector in the top left corner of the
Symbio 700 controller.
•Power up Symbio 700
•Pair the mobile phone with Symbio 700 (reference
guide BAS-SVN043*)
•Enable Bluetooth on phone and on Symbio 700
•Match number on mobile phone app with
number displayed on Symbio 700
•Press checkbox on Symbio 700 to complete
pairing
•Initiate firmware update
•Go to “Tools”
•Select “Update Firmware”
•Select the appropriate firmware file that was
downloaded to the USB mass storage device
NOTE: Update may take 3-5 minutes to
complete, and Bluetooth may be lost.
•When update is completed, Symbio 700 will display
“Update Success” and the Symbio Service and
Installation App will indicate successful update to
the indicated version.
•Power down Symbio 700 and remove USB mass
storage device
4. Verify equipment operation is correct and any BAS settings (if
applicable) are working as intended
5. Take a new backup of the Symbio 700 and discard any
previous backup
Parts Ordering Information
No material is required for this repair.
Material Disposition
Dispose of all parts, including any unused parts and
materials, in accordance with federal, state, and local laws
and ordinances.
Questions
Contact the Light Commercial Technical Support Team if you are a
Trane Distributor or a Commercial Sales Office. Otherwise, please
contact the local Trane distributor or a Commercial Sales Office.
For products sold through Residential, please contact your local FSR.
SS-SVB022A-EN

(New)
Confidential and proprietary Trane Technologies information
©2021 Trane
Trane - by Trane Technologies (NYSE: TT), a global climate innovator - creates comfortable, energy efficient indoor
environments for commercial and residential applications. For more information, please visit trane.com or
tranetechnologies.com.
Trane has a policy of continuous product and product data improvement and reserves the right to change design and specifications without notice. We are
committed to using environmentally conscious print practices.
SS-SVB022A-EN
28 May 2021