TransTel Communications Blue Tooth Phone User manual

TO MAKE INTERCOM / OUTGOING CALLS
To make an intercom call or an outgoing call:
Manual Mode
1. Press the [Answer] button on the headset.
2. Press Extension Number or dial External number
3. To End Call press [Answer] button on headset
Auto Mode
Press Extension number or dial External number
To End Call press SPK button on DK2 Phone
GENERAL OPERATION
To Adjust Speaker Volume during a Call
You can adjust the speaker volume during a call by
pressing the volume control buttons on the side of the Ear
and or the volume control keys on the DK6 phone
according to your preference.
Operation Range
The DK6 Blue Tooth Interface is a very low power radio
communication device. The radio communication range
between the DK6 and the Headset is approximately 10
meters. Please keep both units within this range for best
communication performance.

EAR PIECESETUP
Most headsets will allow you to wear the headset on your
right or left per your preference. Please consult your Blue
Tooth Headset user guide for the setup required.
MAINTAINANCE
As high temperature will shorten the battery life, please do
not leave your Headset in an environment with
temperatures over 100ºF or in direct sunlight.
Keep your Headset away from moisture.
To clean, use soft cloth with mild liquid soap to clean the
exterior of your Cordless Headset and phone. DO NOT
use abrasive chemical detergent or material to clean the
Headset.
DO not attempt to pry open the cover of your Cordless
Headset or change the batteries. Seek assistance from
an AUTHORIZED dealer near you.
TRANSTEL DESIGNS AND MANUFACTURES A SPECIAL
INTERFACE CARD INCOMPLIANCEWITH THE
BLUETOOTH 2.0 SPECIFICATION. THIS IS COMPATIBLE
WITH HEADSETS AVAILABLE THROUGH YOUR LOCAL
DEALER OR GENERALLY AVAILABLE ATMANY RETAIL
OUTLETS. WE RECOMMEND USING HEADSETSWE
HAVE TESTED FORCOMPATABILITY AS LISTEDWITHIN
THIS USER GUIDE. WARRANTY AND PERFORMANCE
OFTHE HEADSET YOU CHOOSE SHALL BE THAT OF
THE RESPECTIVE MANUFACTURER.





HEADSETSPECIFICATIONS
Frequency 2.400~2.4835GHz
Security 128 Bit
Technology Type Blue Tooth
Auto channel hopping Yes
Working range Up to 10 meters
Talk time 4 hours (headset dependant)
Blue Tooth Version 2.0









BLUE TOOTH HEADSETS
The DK6 Phone Blue Tooth interface will integrate with
many brands of headset, we have tested and recommend
the following headsets

Sony HBH-PV702




Plantronics Voyager 510


CONNECTION TO PHONE

No physical connection to the DK6 phone is required.
TO PAIR HEADSETWITH DK6PHONE
Before Pairing:
Please ensure Blue Tooth Headset has had its first
maximum charge as recommended by its manufacturer.
•Hold Headset with Mic Boom closed
•Place Blue Tooth Headset into Pairing Mode by
pressing and holding down the answer key until
LED light comes on
•Open Mic Boom, LED on Headset should remain
on
•Press and hold down the DK6 phones “HOLD” key
until “Pairing” is displayed on phone screen
•Release Hold Key
•Waiting until Blue Tooth Headset LED flashes
rapidly
•Phone and Handset are now Paired
Note: Please ensure you only pair one Blue Tooth Device in
the area of work at any one time
TO ACTIVATE DK PHONE INTO HEADSETMODE
To activate the headset mode on DK6 phone:
•Press [SPK][775] to enable the headset mode.
To cancel the headset mode on DK6 phone:
•Press [SPK][775] to cancel the headset mode.
TO ANSWERINCOMING CALLS
Manual Mode
To answer incoming call:
•When DK6 phones rings the Blue Tooth Headset will
beep in your ear
•To answer call press the [Answer] button on the Blue
Tooth headset.
To end the conversation of a call:
•Press the [Answer] button again will end the call
•The Blue Tooth Headset will beep to indicate call
ended and will automatically put DK6 phone to
idle state.
Note:
•If you press [SPK] button on the DK6 telephone this
will also end the call directly. But the Blue Tooth
Headset will be left in Auto Answer Mode”. If left in
this state the next incoming call will be answered
automatically by the Headset.
Auto Mode
Headset will be in active when in this mode, please note the
battery time will be more limited when using this mode
To answer incoming call:
•When DK6 phones rings the Blue Tooth Headset will
beep in your ear once
•The Headset will then answer call
To end the conversation of a call:
•Press the SPK key on the DK6 phone
Note:
•If you press [SPK] button on the DK6 telephone will
also end the call directly. But the Blue Tooth
Headset will be left in Auto Answer Mode”. If left in
this state the next incoming call will be answered
automatically by the Headset.