Travis Industries 864 Clean Face GSR2 User manual

864 Cleanface GSR2 - Cheat Sheet
Page 1 of 2 17601834 Printed 11/22/16
The 864 Cleanface GSR2 has several new features and characteristics that require special attention
during installation and set-up. Refer to the owner’s manual for full details.
Accessing the Firebox
You will need to remove the screen on this fireplace to access the glass frame and firebox. Remove and
discard the two nuts used to secure the screen during shipping (see illustration below). Next, remove the
concealment cover and screen to access the glass frame.
c
b
Remove the concealment
cover.
Lift the screen up, pivot the top
forward, and remove from the
fireplace.
11/32" Wrench
a
Remove and discard the two
nuts used to secure the
screen during shipping.
HINT FOR REPLACING THE SCREEN: Hold the screen at an
angle and insert the bottom slots first. Then pivot the screen
forward to engage the top hooks.






















864 Cleanface GSR2 - Cheat Sheet
Page 2 of 2 17601834 Printed 11/22/16
GreenSmart™ 2
This heater has GreenSmart™ 2 components from SIT. These components function in a near identical
fashion to the previous GreenSmart™ 1 components. The primary differences are:
• The accent light now has dimming capability built into the remote.
• The pilot may be switched from intermittent (IPI) to standing pilot from the remote.
Refer to the owner’s manual for full details.
Remote Control / Pilot Warnings
Installing batteries in the battery holder or connecting the appliance to power may
automatically initiate the CPI pilot mode, resulting in a lit pilot flame. Do not place
combustibles in the firebox.
KEEP BATTERIES AND COVER
INSTALLED AT ALL TIMES
The remote control system requires the batteries and battery cover to remain
in place at all times. Once the batteries or cover are removed, the system may
re-start in standing pilot mode. If this occurs when the heater is in Remote
Mode, you will not be able to turn the heater off manually from the battery box.
If you need to replace dead batteries, make sure to turn the appliance off
before removing the batteries.
NOTE:If the batteries go dead, the system will operate normally as long as
household power is present.
Installation Warnings
Install Insulation when Converting to Rear Vent Configuration The insulation is
only used for rear vent configurations. Failure to install the insulation will create a safety
hazard.
3” (77mm) Clearance Above Vent when Rear Vented See manual for details.
Top Vent vs. Rear Vent Depending upon top or rear vent configuration, maximum vent
configuration may change. See installation manual for details.
May Use 6-5/8” (169mm) Vent in Top Vent Configuration See manual for details.