Travis Industries DVL EF II User manual

Surround Panels (DVS/DVL EF II)
Page 1 of 2 3/3/06 © Travis Industries, Inc.
Compatibility
• DVS Insert EF II
• DVL Insert EF II
Packing List
• Top, Right, and Left Side Panels
• Panel Trim (with Hardware)
• (4) 10-24 Type F Thread-Cutting Screws
• (7) Spring Clips
Part Numbers
• DVS – 4” by 6” 96100300
• DVS – 8” by 10” 96100301
• DVS – 10” by 13” 96100302
• DVL – 4” by 6” 96100320
• DVL – 8” by 10”” 96100321
• DVL – 10” by 13” 96100322
Inside Fit Panels
The panels may be cut down in size and placed within the fireplace opening. When installed in this configuration,
install the rheostat and on/off switch in the control panel under the firebox (see the owner’s manual for details). For
standard installations, we recommend you attach the rheostat and on/off switch to the upper right surround panel trim
(after the trim is installed).
Installation
Before installation the insert should be in place with the gas line and vent attached. Pull the insert out slightly to
assist in the installation. Attach the side panels then the top panel and trim (see the directions below and on the
following page).
DVS Insert EF II – Side Panel Installation
Line up each side surround
panel and insert two screws from
the inside to secure in place.
5/16" Nutdriver
Pre-thread the holes on the surround
panels with the screws included in the
surround panel kit.
b
a
Run the rheostat wires,
on/off switch wires, and
power cord through the
access hole on the
insert

Surround Panels (DVS/DVL EF II)
Page 2 of 2 3/3/06 © Travis Industries, Inc.
DVL Insert EF II – Side Panel Installation
Line up each side surround
panel and insert two screws from
the inside to secure in place.
5/16" Nutdriver
Pre-thread the holes on the surround
panels with the screws included in the
surround panel kit.
b
a
Run the rheostat wires,
on/off switch wires, and
power cord through the
access hole on the
insert
DVS and DVL Insert EF II – Top Panel and Trim Installation
Top
Panel
Top Trim
"L" Bracket
Right Side Trim
Slot for on/off
switch and hole
for rheostat
a
"L" Bracket
Right Side
Trim
Top Trim
Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Micro (1/16”)
Standard
Screwdriver
A
Spring
Clips
Optional Knock-Out
An optional knock-out is provided on both sides if the
power cord is routed behind the surround panel.
Install the top panel so
the tabs insert into the
joggle clips on the top
panel
A
A
A
A
A
A
b