Travis Industries 616 Diamond-Fyre GSR User manual

616 / 430 Fireback Installation Instructions
Page 1 of 3 17601680 — 7/14/15 © Travis Industries, Inc.
Compatibility
616 GSR, GSR2 SKU’s: 96100924, 926, 927, 928, 929
430 GSR2 SKU’s: 96100917, 918, 919, 920, 921
Packing List

Rear, Left and Right Firebacks
NOTE FOR CERAMIC FIREBACKS:
The rear fireback is rectangular and must be
placed right-side-up. Lay the firebacks on a flat
surface prior to installing to verify the grout lines
are aligned.
STAINLESS STEEL WARNINGS
HANDLING THE FIREBACKS: The stainless steel firebacks are shipped in vinyl to prevent marring the
surface of the stainless steel. Remove the vinyl prior to installation. Wear clean gloves when
installing the firebacks to prevent fingerprints on the surface (or use a rag or paper towel to handle
the firebacks).
COLORATION AND CLEANING: These stainless steel firebacks will obtain a slight “patina” (brown
tint) after use. Do not clean the firebacks. This patina becomes consistent. Any cleaning may lead to
unequal coloring. If soot forms on the fireback, we recommend brushing it off with a soft cloth or brush.
CLEANING ENAMEL FIREBACKS
We recommend cleaning the enamel surface with glass cleaner and a soft cloth.
CURING BLACK PAINTED FIREBACKS
The black painted firebacks will fully cure under heat. Run the appliance on low for several hours to
cure the paint. The firebacks may be touched-up using Forrest “Metallic Black” paint.

616 / 430 Fireback Installation Instructions
Page 2 of 3 17601680 — 7/14/15 © Travis Industries, Inc.
Installation
The firebacks are installed with the burners removed.
See the owner’s manual for full details on order of installation.
1. Remove the burner (see Owner’s Manual).
2. Remove the two side fireback clips from the firebox ceiling. They are located at the outward edges of
the firebox near the glass opening.
3. Place the rear fireback inside the firebox as shown below.
Metal Fireback Orientation
Make sure the notch is upwards when installing.
The side fireback clip
has a keyhole slot. It
can be removed by
loosening the screw
and sliding the clip out.
Up
430 LightShields
Removethetwolightshieldsonthe430
beforeinstallingthefireback.Replace
afterfirebacksareinplace.

616 / 430 Fireback Installation Instructions
Page 3 of 3 17601680 — 7/14/15 © Travis Industries, Inc.
4. While holding the rear fireback, install the right fireback into the firebox as shown below.
5. Replace the right fireback clip to secure the right fireback in place
6. Install the left fireback and secure using the fireback clip. The firebox should now look like the photo
below.