TRENDnet TEG-PCBUSR User manual

FCC Warning
This equipment has been tested and found to comply with the
regulations for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with this user’s guide,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
CE Mark Warning
This is a Class B product. In a domestic environment, this
product may cause radio interference, in which case the user
may be required to take adequate measures.
VCCI Mark Warning

Table Of Contents
INTRODUCTION.................................................................. 1
GENERAL DESCRIPTION.......................................................... 1
LED INDICATORS................................................................... 1
SUMMARY OF FEATURES......................................................... 2
CARD INSERTION AND REMOVAL................................ 3
CARD INSERTION.................................................................... 3
[1] Insert the 32-bit CardBus 10/100/1000Mbps Gigabit
Ethernet PC Card............................................................. 3
[2] Connect to the Network Media................................... 4
CARD REMOVAL ..................................................................... 4
DRIVER INSTALLATION................................................... 5
TECHNICAL SPECIFICATIONS....................................... 6

1
Introduction
General Description
The 32-bit CardBus 10/100/1000Mbps Gigabit Ethernet PC Card is a
credit-card sized Fast Ethernet adapter for connecting a notebook to an
IEEE 802.3 Ethernet network, IEEE 802.3u fast Ethernet and IEEE
802.3ab Gigabit Ethernet network, it’s designed to work with
notebooks or handheld computers that with CardBus slots. Inside its
compact package, the 32-bit CardBus 10/100/1000Mbps Gigabit
Ethernet PC Card holds the Gigabit Ethernet controller, network
processing interface, RAM for the data buffer a, 68-pin PC Card plug
and RJ-45 10/100/1000Mbps Gigabit Ethernet port. It requires no
pre-installation setup -- simply insert the PC Card into the computer's
32-bit CardBus slot.
The 32-bit CardBus 10/100/1000Mbps Gigabit Ethernet PC Card
features LED indicators for Link/Activity, and Speed.
LED Indicators
The 32-bit CardBus 10/100/1000Mbps Gigabit Ethernet PC Card
provides two LED indicators:
1. Link/Activity
(Link/ACT)
¾This indicator lights green when the RJ-45 port is
connected to a Ethernet network, if the indicator blinking
green will be transmissing/received data to/from the
Ethernet network.
2. Link Speed Indicator (SPEED)
¾The indicator lights green when the port is connected to
1000Mbps Gigabit Ethernet Network and the indicator
lights amber when the port is connected to 100Mbps Fast

2
Ethernet Network. Otherwise, this indicator remains off
when the port is connected to a 10Mbps Ethernet Network.
Summary of Features
The 32-bit CardBus 10/100/1000Mbps Gigabit Ethernet PC Card
provides the following features:
¾Complies with IEEE 802.3 10BASE-T Ethernet standard
¾Complies with IEEE 802.3u 100BASE-TX Fast Ethernet
standard
¾Complies with IEEE 802.3ab 1000BASE-T Gigabit Ethernet
standard
¾Complies with ANSI / IEEE 802.3 Auto-Negitiation standard
¾Complies with 32-bit CardBus Standard
¾Supports Crossover Detection & Auto-Correction
¾Built-in Transmit/Reveive FIFO data buffer (8K/64K)
¾No manual setup switches -- automatically configured by
software
¾Low power consumption
¾Supported driver list:
Microsoft Windows XP
Microsoft Windows 2000
Microsoft Windows Me
Microsoft Windows 98SE
Microsoft Network Client for DOS (NDIS 2 driver)
NetWare Client for DOS (ODI driver)

3
Card Insertion and Removal
Card Insertion
Follow these steps to install the 32-bit CardBus
10/100/1000Mbps Gigabit Ethernet PC Card:
[1] Insert the 32-bit CardBus 10/100/1000Mbps Gigabit
Ethernet PC Card
Find/select an available Type II or Type III 32-bit PC Card slot
on your notebook’s side or rear panel. Holding the 32-bit
CardBus 10/100/1000Mbps Gigabit Ethernet PC Card with the
LED indicator facing up then insert to the 32-bit PC Card slot.
Slide the 32-bit CardBus 10/100/1000Mbps Gigabit Ethernet
PC Card all the way into the 32-bit PC Card slot until it reaches
a firm stop.

4
[2] Connect to the Network Media
Simply plug one end of the cable (RJ-45 connector) into an
available hub/switch port, and plug the other end (RJ-45
connector) into the RJ-45 port of your 32-bit CardBus
10/100/1000Mbps Gigabit Ethernet PC Card.
Card Removal
Use the computer's PC Card Eject mechanism to unseat the
32-bit CardBus 10/100/1000Mbps Gigabit Ethernet PC Card
from the computer's PC Card slot. The PC Card will then
protrude from the PC Card slot and you can easily remove the
PC Card by gripping its protruding end and withdrawing it
from the PC Card receptacle.

5
Driver Installation
Before you connect the 32-bit CardBus 10/100/1000Mbps
Gigabit Ethernet PC Card to the network, you have to install
the network driver first. The driver for each networking
operating system is under a separate directory. A
HELPME.EXE file under root directory lists the information
and detailed installation procedure of all the available drivers.
Card insertion as described in Chapter “Card Insertion and
Removal” must be completed before you proceed with
software installation.

6
Technical Specifications
General
Standards IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3ab 1000BASE-T Gigabit Ethernet
ANSI/IEEE Auto-Negotiation
32-bit CardBus PC Card
Protocol CSMA/CD
Data Transfer
Rate Ethernet: 10Mbps (half-duplex)
20Mbps(full-duplex)
Fast Ethernet: 100Mbps (half-duplex)
200Mbps (full-duplex)
Gigabit Ethernet: 2000Mbps (full-duplex)
Network Cables 10BASE-T: 2-pair UTP Cat. 3,4,5
EIA/TIA- 568 100-ohm STP
100BASE-TX: 2-pair UTP Cat. 5
EIA/TIA- 568 100-ohm STP
1000BASE-T: 4-pair UTP Cat. 5e
EIA/TIA- 568 100-ohm STP
Physical and Environmental
Temperature Operating: 0°~ 40°C, Storage: -10°~ 70°C
Humidity Operating: 10% ~ 90%, Storage: 5% ~ 90%
EMI: FCC Class B, CE Mark B, VCCI-B

Limited Warranty
TRENDware warrants its products against defects in
material and workmanship, under normal use and service,
for the following lengths of time from the date of
purchase.
Ethernet Products – 5 Years Warranty
If a product does not operate as warranted above during
the applicable warranty period, TRENDware shall, at
its option and expense, repair the defective product
or part, deliver to customer an equivalent product or
part to replace the defective item, or refund to
customer the purchase price paid for the defective
product. All products that are replaced will become
the property of TRENDware. Replacement products may
be new or reconditioned.
TRENDware shall not be responsible for any software,
firmware, information, or memory data of customer

contained in, stored on, or integrated with any
products returned to TRENDware pursuant to any
warranty.
There are no user serviceable parts inside the product.
Do not remove or attempt to service the product by any
unauthorized service center. This warranty is voided
if (i) the product has been modified or repaired by any
unauthorized service center, (ii) the product was
subject to accident, abuse, or improper use (iii) the
product was subject to conditions more severe than
those specified in the manual.
Warranty service may be obtained by contacting
TRENDware office within the applicable warranty period
for a Return Material Authorization (RMA) number,
accompanied by a copy of the dated proof of the purchase.
Products returned to TRENDware must be pre-authorized
by TRENDware with RMA number marked on the outside of
the package, and sent prepaid, insured and packaged
appropriately for safe shipment.

WARRANTIES EXCLUSIVE: IF THE TRENDWARE PRODUCT DOES
NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER’S SOLE
REMEDY SHALL BE, AT TRENDWARE’S OPTION, REPAIR OR
REPLACEMENT. THE FOREGOING WARRANTIES AND REMEDIES ARE
EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION
OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. TRENDWARE NEITHER ASSUMES NOR AUTHORIZES ANY
OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN
CONNECTION WITH THE SALE, INSTALLATION MAINTENANCE OR
USE OF TRENDWARE’S PRODUCTS.
TRENDWARE SHALL NOT BE LIABLE UNDER THIS WARRANTY IF
ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED
DEFECT IN THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY
CUSTOMER’S OR ANY THIRD PERSON’S MISUSE, NEGLECT,
IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED
ATTEMPTS TO REPAIR OR MODIFY, OR ANY OTHER CAUSE BEYOND
THE RANGE OF THE INTENDED USE, OR BY ACCIDENT, FIRE,
LIGHTNING, OR OTHER HAZARD.
LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY
LAW TRENDWARE ALSO EXCLUDES FOR ITSELF AND ITS
SUPPLIERS ANY LIABILITY, WHETHER BASED IN CONTRACT OR

TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL,
CONSEQUENTIAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES
OF ANY KIND, OR FOR LOSS OF REVENUE OR PROFITS, LOSS
OF BUSINESS, LOSS OF INFORMATION OR DATE, OR OTHER
FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE
SALE, INSTALLATION, MAINTENANCE, USE, PERFORMANCE,
FAILURE, OR INTERRUPTION OF THE POSSIBILITY OF SUCH
DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR,
REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT
TRENDWARE’S OPTION. THIS DISCLAIMER OF LIABILITY FOR
DAMAGES WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED
HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE.
Governing Law: This Limited Warranty shall be governed
by the laws of the state of California.

Technical Support
You can find the most recent driver/firmware
/software and user documentations on the
TRENDware website. TRENDware provides FREE
technical support for all customers for the duration
of the warranty period on this product.
TRENDware Technical Support
Tel: [phone]
Fax: [phone]
E-mail: [e-mail]
www.TRENDnet.com
Monday ~ Friday, 7:30AM ~ 6:00PM Pacific
Standard Time
(Except holidays)