TRENDnet TEV-639GR User manual

1

2
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The availability of some specific channels and/or operational frequency bands are country
dependent and are firmware programmed at the factory to match the intended destination. The
firmware setting is not accessible by the end user.
Copyright
This publication, including all photographs, illustrations and software, is protected under international
copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may
be reproduced without written consent of the author.
Copyright 2006
Trademark recognition
All product names used in this manual are the properties of their respective owners and are acknowledged.

3
Table of Contents
Getting Started............................................................................................5
Package Contents....................................................................................5
Minimum System Requirements ..............................................................5
Introduction.................................................................................................6
Features...................................................................................................6
Wireless Performance Considerations.....................................................7
Overview.....................................................................................................8
Network Diagram .....................................................................................8
FronT panel (LEDs):.................................................................................8
Rear panel:...............................................................................................8
Using the Configuration Menu ....................................................................9
Network.....................................................................................................10
WAN Setting...........................................................................................10
LAN Setting............................................................................................12
QoS........................................................................................................14
DHCP Client List....................................................................................14
Wireless....................................................................................................15
Basic ......................................................................................................15
Advanced...............................................................................................17
MAC Filter..............................................................................................18
Security..................................................................................................19
WPS.......................................................................................................20
Station List..............................................................................................21
Advanced..................................................................................................21
DMZ .......................................................................................................21
Virtual Server .........................................................................................22
Routing...................................................................................................23
Access Control.......................................................................................24
Special Applications ...............................................................................25
Gaming...................................................................................................26
Inbound Filter.........................................................................................27
Schedule................................................................................................28
Advance Network...................................................................................29
Administrator.............................................................................................30
Wizard....................................................................................................30

4
Management..........................................................................................30
Upload Firmware....................................................................................31
Setting Management..............................................................................32
Time .......................................................................................................32
Status .....................................................................................................33
Help...........................................................................................................34
Network Glossary .....................................................................................35
Specifications............................................................................................38
Limited Warranty.......................................................................................39

5
Getting Started
Congratulations on purchasing the TEW-639GR! This manual provides information for setting up and
configuring the TEW-639GR. This manual is intended for both home users and professionals.
PACKAGE CONTENTS
TEW-639GR 2.4GHz 300Mbps Wireless N Gigabit Router
CD-ROM (User’s Guide)
Multi-Language Quick Installation Guide
1 x Network cable
Power Adapter (12V, 1A)
Using a power supply with a different voltage than the one included with your product will cause damage
and void the warranty for this product. If any item is found missing or damaged, please contact your local
reseller for replacement.
MINIMUM SYSTEM REQUIREMENTS
Ethernet-Based Cable or DSL Modem
Computers with Windows, Macintosh, or Linux-based operating systems with an installed Ethernet
adapter and CD-ROM Drive
Internet Explorer Version 6.0 or Netscape Navigator Version 7.0 and Above

6
Introduction
The TEW-639GR 2.4GHz 300Mbps Wireless N Gigabit Router is an high-performance, wireless router that
supports high-speed wireless networking at home, at work or in public places.
Unlike most routers, the TEW-639GR provides data transfers at up to 300Mbps when using 11n connection.
This router is also back compatible with 802.11g or 11b devices. This means that you do not need to
change your entire network to maintain connectivity. You may sacrifice some of 11n’s speed when you mix
11n and 11b/g devices, but you will not lose the ability to communicate when you incorporate the 11n
standard into your 11b/g network. You may choose to slowly change your network by gradually replacing
the 11b/g devices with 11n devices.
FEATURES
4 x 10/100/1000Mbps Auto-MDIX LAN ports
1 x 10/100/1000Mbps WAN port (Internet)
1 x external wireless radio on/off switch (turn off your wireless network when away)
1 x external Wi-Fi Protected Setup (WPS) button
One-touch wireless security setup using the Wi-Fi Protected Setup (WPS) button when connecting to a
WPS adapter
Wireless Distribution System (WDS) support
Compatible with most popular cable/DSL Internet service providers using Dynamic/Static IP, PPPoE,
PPTP and L2TP
High-speed wireless data rates up to 300Mbps using an IEEE 802.11n connection
3 external antennas provide high-speed performance and expansive wireless coverage
Advanced Firewall protection with Network Address Translation (NAT) and Stateful Packet Inspection
(SPI)
Access restriction with Internet Access Control; time scheduling and MAC filtering
Built-in pre-configured virtual servers and Application Level Gateway services for special Internet
applications
Universal Plug and Play (UPnP) for auto discovery and support for device configuration of Internet
applications
Multiple pass-through sessions for popular VPN applications (IPSec, L2TP and PPTP)
WMM quality of service support
Easy setup via Web browser using the latest versions of Internet Explorer, FireFox, Safari, and Chrome

7
WIRELESS PERFORMANCE CONSIDERATIONS
There are a number of factors that can impact the range of wireless devices.
1. Adjust your wireless devices so that the signal is traveling in a straight path, rather than at an angle.
The more material the signal has to pass through the more signal you will lose.
2. Keep the number of obstructions to a minimum. Each obstruction can reduce the range of a wireless
device. Position the wireless devices in a manner that will minimize the amount of obstructions
between them.
3. Building materials can have a large impact on your wireless signal. In an indoor environment, try to
position the wireless devices so that the signal passes through less dense material such as dry wall.
Dense materials like metal, solid wood, glass or even furniture may block or degrade the signal.
4. Antenna orientation can also have a large impact on your wireless signal. Use the wireless adapter’s site
survey tool to determine the best antenna orientation for your wireless devices.
5. Interference from devices that produce RF (radio frequency) noise can also impact your signal. Position
your wireless devices away from anything that generates RF noise, such as microwaves, radios and
baby monitors.
6. Any device operating on the 2.4GHz frequency will cause interference. Devices such as 2.4GHz
cordless phones or other wireless remotes operating on the 2.4GHz frequency can potentially drop the
wireless signal. Although the phone may not be in use, the base can still transmit wireless signal.
Move the phone’s base station as far away as possible from your wireless devices.
If you are still experiencing low or no signal consider repositioning the wireless devices or installing
additional access points. The use of higher gain antennas may also provide the necessary coverage
depending on the environment.
limit the range. Typical ranges vary depending on the types of materials and background RF (radio
frequency) noise in your home or business. The key to maximizing wireless range is to follow these basic
guidelines:
1 Keep the number of walls and ceilings between the TEW-639GR and other network devices to a
minimum - each wall or ceiling can reduce your wireless products range from 3-90 feet (1-30 meters.)
Position your devices so that the number of walls or ceilings is minimized.
2 Be aware of the direct line between network devices. A wall that is 1.5 feet thick (.5 meters), at a
45-degree angle appears to be almost 3 feet (1 meter) thick. At a 2-degree angle it looks over 42 feet
(14 meters) thick! Position devices so that the signal will travel straight through a wall or ceiling (instead
of at an angle) for better reception.
3 Building Materials can impede the wireless signal - a solid metal door or aluminum studs may have a
negative effect on range. Try to position wireless devices and computers with wireless adapters so that
the signal passes through drywall or open doorways and not other materials.
4 Keep your product away (at least 3-6 feet or 1-2 meters) from electrical devices or appliances that
generate extreme RF noise.

8
Overview
NETWORK DIAGRAM
FRONT PANEL (LEDS):
•PWR
•WAN
•LAN1
•LAN2
•LAN3
•LAN4
•Wireless
•WPS
REAR PANEL:
•DC-IN
•RESET
•WAN
•LAN1
•LAN2
•LAN3
•LAN4

9
Using the Configuration Menu
Whenever you want to configure your TEW-639GR, you can access the Configuration Menu through
your PC by opening the Web-browser and typing in the IP Address of the TEW-639GR. The
TEW-639GR’s default IP Address is http://192.168.10.1
•Open the Web browser.
•Type in the IPAddress of the Router (http://192.168.10.1 )
If you have changed the default IP Address assigned to the TEW-639GR, make sure to
enter the correct IP Address.
•Select admin in the User Name field.
•Default password is admin.
•Click OK.

10
Network
WAN SETTING
WAN Connection Type: There are several connection types to choose from: Static IP, DHCP,
PPPoE, PPTP, L2TP, and Russia PPTP. If you are unsure of your connection method, please contact
your Internet Service Provider.
Static: Used when your ISP provides you a set IP address that does not change. The IP information is
manually entered in your IP configuration settings. You must enter the IP address, Subnet Mask,
Gateway, Primary DNS Server, and Secondary DNS Server. Your ISP provides you with all of this
information.
DHCP: A method of connection where the ISP assigns your IP address when your router requests one
from the ISP's server.
Host Name: Some ISP's may check your computer's Host Name. The Host Name identifies your
system to the ISP's server.
PPPoE: Select this option if your ISP requires you to use a PPPoE (Point to Point Protocol over
Ethernet) connection. DSL providers typically use this option. This method of connection requires you
to enter a Username and Password (provided by your Internet Service Provider) to gain access to
the Internet.
Reconnect Mode: Typically PPPoE connections are not always on. The router allows you to set the
reconnection mode. The settings are:
Always on: A connection to the Internet is always maintained.
On demand: A connection to the Internet is made as needed.
Manual: You have to open up the Web-based management interface and click the Connect button
manually any time that you wish to connect to the Internet.