TRENDnet TEG-S80g - Switch User manual

TEG-S80g
1.02
Quick Installation Guide

Table of Contents
Table of Contents
Version 06.26.2009
English ......................................................................................................
Technical Specifications .............................................................................
Troubleshooting ..........................................................................................
1
1
3
5
6
1. Before You Start
2. Hardware Installation .........................................................................
3. LEDs ..................................................................................................
.................................................................................
4

Installation Requirements
?Acomputer with a network adapter installed
?Cat-5e or Cat-6 Network Cable
?
?
?
?
?
The surface must support at least 1.5 Kg for the Switch
The power outlet should be within 1.82 meters (6 feet) of the Switch
Visually inspect the DC power jack to make sure that it is securely
connected to the power adapter
Make sure that there is proper heat dissipation from and adequate
ventilation around the Switch
Do not place heavy objects on the Switch
Package Contents
1. Before You Start
English
1
?TEG-S80g
?Multi-Language Quick Installation
Guide
?AC PowerAdapter (7.5V DC, 1A)

English
2
Application
60m
Full Power
60m
100m
100m
20m
Regular
Switch
GREENnet
Switch
20m
Delivers less power
with shorter
cable lengths
3
Delivers less power
to unused ports
1
on on
less power
Delivers less power
when devices are off
2
on on
off less power
*Max power savings compared with standard TRENDnet switches.

2. Hardware Installation
English
3
1. Connect the AC PowerAdapter to
the TEG-S80g and then to a power
outlet.
2. Connect a CAT-5e or CAT-6 RJ-45
network cable from the computer to
an available Ethernet port of the
TEG-S80g.

3. LEDs
English
4
100/1000Mbps
Green: Connection for the port is
1000 (Full/Half)
Amber: Connection for the port
is 100 (Full/Half)
Not Illuminated: Connection for
the port is 10(Full/Half) or
nothing is detected on the port.
Link/ACT
Green(Solid): Link to another
device.
Green(Blinking):Activity is
occurring from the link
Not Illuminated: Nothing is
detected on the port.
Power
Green:Powerison.
NotIlluminated:Powerisoff.

5
Standards IEEE 802.3 10Base-T
IEEE 802.3u 100Base-TX
IEEE 802.3ab 1000Base-T
IEEE 802.3x Flow Control
Network Media Ethernet: 2-Pair UTP/STP CAT-3, -4, -5
Fast Ethernet: 2-Pair UTP/STP CAT-5, -5e , -6
Gigabit : 4-Pair UTP/STP CAT-5e, CAT-6
(Recommended)
Data Transfer Rate Ethernet: 10Mbps (half-duplex), 20Mbps (full-duplex)
Fast Ethernet: 100Mbps (half-duplex), 200Mbps
(full-duplex)
Gigabit Ethernet: 2000Mbps (full-duplex)
Interface 8 x 10/100/1000Auto-MDIX RJ-45 ports
Data RAM Buffer 128Kbytes per device
Hardware
Packet Filtering/Forwarding Rate 10Mbps Ethernet: 14,880pps (packet per second)
Technical Specifications
Protocol/Topology CSMA/CD / Star
Filtering Table
MACAddress Learning
Switch Fabric
Power Consumption
Jumbo Frame Support TEG-S80g: Up to 9612Bytes
Automatic Update
4K entries per device
16Gbps Forwarding Capacity
5W (max)
Diagnostic LEDs Power, Link/ACT, 100/1000Mbps
PowerAdapter 7.5V DC, 1AExternal PowerAdapter
Dimensions 171 x 98 x 28 mm (6.7 x 3.86 x 1.1 in.)
Certifications CE, FCC
* Max power savings compared with standard TRENDnet switches.
100Mbps Fast Ethernet: 148,800pps
1000Mbps Gigabit Ethernet: 1,488,000pps
Weight 450g
Temperature Operating: 0° ~ 40° C (32° ~ 104° F)
Storage: -10° ~ 70° C (14° ~ 158° F)
Humidity Operating: 10% ~ 90% Storage: 5% ~ 90%

10
2. ????????? ????????????
6
Troubleshooting
Q1: A1:
Q2:
A2:
Q3: A3:
Q4:
A4:
Q5: A5:
After connecting the Switch to a power outlet, the LEDs do not turn on.
Check the connection of the external power adapter to the TEG-S80g and the
power outlet.Also check that the power outlet is receiving power.
When I connect a computer to one of the ports on the Switch, the Power and
the Link/ACT LED is lit, but I am not getting Gigabit speeds.
First, check the LEDs. If the 100/1000Mbps LED is amber, the computer's
connection speed is 100. If the 100/1000Mbps LED is off, the computer's
connection speed is 10Mbps. . Second, check the Ethernet Cable. Make sure
you are using CAT-5e or CAT-6 Ethernet Cables. Some CAT-5 cables are not
rated to run in Gigabit. Third, make sure that you have a Gigabit Ethernet adapter
installed on your computer.
After I connect my PCs to the Switch, I am unable to share files.
First, check the LEDs on the Switch. Make sure the Link/ACT LED is on.
Second, check the network cable. The minimum length of the cable is 1.5 meters
and the maximum length of the cable is 100 meters. Third, disable any software
firewall program. Fourth, verify that you have file sharing enabled. Please contact
your Operating System support for more information.
After I connect my PCs to the Switch, I can only get onto the Internet from one
computer.
The Switch was not designed to share Internet between multiple computers.
You need to get an Internet router such as the TW100-S4W1CA.
Where is the uplink port located on the Switch?
Since all the ports on the Switch areAuto-MDIX, any of the ports can be used
as an uplink port.
If you still encounter problems or have any questions regarding the TEG-S80g please
contact Trendnet'sTechnical Support Department.

7
Limited Warranty
- 5 Year Limited Warranty
AC/DC PowerAdapter, Cooling Fan and Power Supply carry 1 year warranty
TRENDnet warrants its products against defects in material and workmanship, under normal
use and service, for the following lengths of time from the date of purchase.
TEG-S80g
If a product does not operate as warranted during the applicable warranty period, TRENDnet
shall reserve the right, at its expense, to repair or replace the defective product or part and
deliver an equivalent product or part to the customer.The repair/replacement unit's warranty
continues from the original date of purchase.All products that are replaced become the
property of TRENDnet. Replacement products may be new or reconditioned.TRENDnet
does not issue refunds or credit. Please contact the point-of-purchase for their return policies.
TRENDnet shallnot beresponsible forany software,firmware, information,or memorydata of
customer contained in, stored on, or integrated with any products returned to TRENDnet
pursuanttoanywarranty.
Therearenouserserviceablepartsinsidetheproduct. Donotremoveorattempttoservicethe
productbyany unauthorizedservicecenter. This warrantyisvoidedif (i)theproducthasbeen
modifiedorrepairedbyanyunauthorizedservicecenter,(ii)theproductwassubjecttoaccident,
abuse, or improper use (iii) the product was subject to conditions more severe than those
specifiedinthemanual.
Warranty service may be obtained by contacting TRENDnet within the applicable warranty
period and providing a copy of the dated proof of the purchase. Upon proper submission of
requireddocumentationaReturn MaterialAuthorization (RMA)numberwillbe issued.An RMA
number is required in order to initiate warranty service support for all TRENDnet products.
ProductsthataresenttoTRENDnetforRMAservicemusthavetheRMAnumbermarkedonthe
outsideofreturnpackagesandsenttoTRENDnetprepaid,insuredandpackagedappropriately
forsafeshipment.CustomersshippingfromoutsideoftheUSAandCanadaareresponsiblefor
return shipping fees. Customers shipping from outside of the USAare responsible for custom
charges,includingbutnotlimitedto,duty,tax,andotherfees.

8
WARRANTIES EXCLUSIVE: IF THE TRENDNET PRODUCT DOES NOT OPERATE AS
WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT TRENDNET'S
OPTION, REPAIR OR REPLACE. THE FOREGOING WARRANTIES AND REMEDIES ARE
EXCLUSIVEANDARE IN LIEU OFALLOTHER WARRANTIES, EXPRESSED OR IMPLIED,
EITHERINFACTORBYOPERATIONOFLAW,STATUTORYOROTHERWISE,INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
TRENDNET NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME
FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION
MAINTENANCEORUSEOFTRENDNET'SPRODUCTS.
TRENDNET SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND
EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN THE PRODUCT DOES NOT
EXISTORWASCAUSEDBYCUSTOMER'SORANYTHIRDPERSON'SMISUSE,NEGLECT,
IMPROPER INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR OR
MODIFY, ORANY OTHER CAUSE BEYOND THE RANGE OFTHE INTENDED USE, OR BY
ACCIDENT,FIRE,LIGHTNING,OROTHERHAZARD.
LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW TRENDNET ALSO
EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN
CONTRACTORTORT(INCLUDINGNEGLIGENCE),FORINCIDENTAL,CONSEQUENTIAL,
INDIRECT,SPECIAL,ORPUNITIVEDAMAGESOFANYKIND,ORFORLOSSOFREVENUE
OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATE, OR OTHER
FINANCIALLOSSARISINGOUTOFORINCONNECTIONWITHTHESALE,INSTALLATION,
MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION OF THE
POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR,
REPLACEMENT,ORREFUNDOFTHEPURCHASEPRICEPAID,ATTRENDNET'SOPTION.
THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF ANY
REMEDYPROVIDEDHEREINSHALLFAILOFITSESSENTIALPURPOSE.
GoverningLaw:ThisLimitedWarrantyshallbegovernedbythelawsofthestateofCalifornia.
SomeTRENDnetproductsincludesoftwarecodewrittenbythirdpartydevelopers.Thesecodes
aresubjecttotheGNUGeneralPublicLicense("GPL")orGNULesserGeneralPublicLicense
("LGPL").
Go to or Download section and look for
the desired TRENDnet product to access to the GPL Code or LGPL Code. These codes are
distributed WITHOUT WARRANTY and are subject to the copyrights of the developers.
TRENDnet does not provide technical support for these codes. Please go to
or for specific terms of
eachlicense.
http://www.trendnet.com/gpl http://www.trendnet.com
http://www.gnu.org/licenses/gpl.txt http://www.gnu.org/licenses/lgpl.txt
PWP05202009v2