Add En{jineOil and Fuel
•Placepressure washer on a levelsurface•
NOTE:Verify provided oil bottle isthe correct viscosity for
current ambient temperature•
•Referto engine operator's manualand follow oil and
fuel recommendationsand instructions•
NOTICE
Anyattempt to crank OFstart the engine before it has been
properly filled with the recommendedoil will result in
_ment failure•
Referto enginemanualfor oilandfuelfill information•
Damagetoequipmentresultingfromfailuretofollowthis
instructionwillvoidwarranty•
NOTE:Checkoil often during engine break-in• Referto
engine operator's manualfor recommendations•
ConnectHoseand Water Supply to Pump
NOTICE
DONOTFunthe pump without the water supply connected
and turned on. _ _ _ m
I" Damagetoequipmentresultingfromfailuretofollowthis
hinstructionwillvoidwarranty•
NOTE:Removeand discard the shipping caps from the
pump's high pressure outlet and water inlet beforeattaching
hoses•
1. Uncoil high pressure hoseand attachone end of hose
to baseof spray gun. Tighten by hand•
WARNING
The high pressurestream of water that this
_ quipment produces can cut through skin and its
underlyingtissues, leadingto serious injury and
3ossible amputation•
•NEVERconnecthighpressurehoseto nozzleextension•
, Keephighpressurehoseconnectedto pumpandspraygun
whilesystemis pressurized•
, Alwaysbecertainspraygun,nozzlesandaccessoriesare
correctlyattached•
2. Attach other end of high pressure hoseto high
pressure outlet on pump• Tighten by hand•
3. Run water through your garden hosefor 30 secondsto
clean outany debris•
IMPORTANT:DONOTsiphon standing water for the water
supply• UseONLYcold water (less than I O0°F).
4. Beforeconnecting garden hoseto water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or
haveit replacedif damaged•DONOTFunpressure
washer if inlet screen is damaged•
5. Connectthe garden hose (not to exceed50 feet in
length) to the water inlet•Tighten by hand•
NOTICE
Damageto pump or water inlet connector will occur if a
OneWay Valve (vacuumbreakeror check valve) is
connectedto pump•
ThereM/USTbeatleasttenfeet(31Vl)of unrestrictedgarden
hosebetweenthepressurewasherinletandanydevice,suchas
aOneWayValve•
Damageto equipmentcausedbyattachinga OneWayValveto
pumpwill voidwarranty•
6. Turn ONthe water and squeezethe trigger on the spray
gun to purge the pump system of air and impurities•
WARNING
Riskof eyeinjury.
• _ ISpray cansplash back or propel objects•
Alwayswearsafetygoggleswhenusingthis equipmentor in
vicinityofwhereequipmentisin use.
Beforestartingthepressurewasher,besureyouarewearing
adequatesafetygoggles•
NEVERsubstitutesafetyglassesforsafetygoggles•
Checklist Before Starting Engine
Reviewthe unit's assembly to ensureyou haveperformed all
of the following•
1. Be sureto readthe OperatorSafetysection and How to
Use Your Pressure Washerin Operationsection before
using pressure washer•
2. Make sure handle is in placeand secure•
3. Checkthat oil hasbeen addedto proper levelin the
engine crankcase•
4. Add proper fuel to fueltank•
5. Checkfor properly tightened hose connections•
6. Checkto makesure there are no kinks, cuts, or damage
to high pressure hose•
7. Providea proper water supply at an adequateflow•
CD
3
