Trudell Medical International AeroChamber Plus Flow-Vu Chamber User manual

1
Remove cap from the inhaler. Shake the inhaler immediately before use as per the
instructions supplied with it.
2
Insert the inhaler into the backpiece of the chamber. Apply mask to face and ensure an
effective seal.
3
Exhale then press the inhaler once at the beginning of a slow inhalation. Hold mask in place
and breathe in and out through the chamber for 5-6 breaths.
HOW TO USE YOUR CHAMBER
Adult Large Mask
108638-001 Rev B. * trade-marks and registered trade-marks of
Trudell Medical International. © TMI 2019. All rights reserved.
INTENDED USE
This chamber is intended to be used along with a metered dose inhaler to deliver aerosol
medication to your lungs as prescribed by your healthcare provider. If you have questions about
the performance or use of this product, please contact your healthcare provider.
BEFORE EACH USE
This chamber can be used directly out-of-package. Ensure these instructions and the instructions
supplied with the inhaler have been read and are kept available at all times. Carefully examine the
chamber and replace immediately if it is damaged or has missing parts.
Notes
SLOW DOWN if you hear the whistle sound (it means you are inhaling too quickly).
If someone is helping you they can use the Flow-Vu* Inhalation Indicator to ensure a
good seal, coordinate pressing the inhaler with inhalation and to count the number of
breaths taken. The Flow-Vu* Indicator moves toward you as you inhale and only moves
if you have a proper seal.
Administer one (1) puff at a time. Follow instructions supplied with the inhaler on how
long to wait before repeating.
Visit www.aerochamber.com for instructional videos
1 2 3
Trudell Medical UK Limited
Manufactured by: Trudell Medical International
725 Baransway Drive, London, Ontario, Canada N5V 5G4
Emergo Europe
Prinsessegracht 20
2514 AP The Hague
The Netherlands
Distributed in the United Kingdom by:
Trudell Medical UK Limited
[email protected] / 01256 338400
62860108504011

This chamber can be used right out-of-package and then cleaned weekly.
1
Remove the backpiece (D). To detach the frontpiece (B), twist chamber as shown.
2
Soak the parts for 15 minutes in a mild solution of liquid dish detergent and lukewarm clean water.
Agitate gently. Rinse parts in clean water. OR Place parts in top rack of dishwasher. Ensure product
is securely placed face up. Run the dishwasher on a normal or light cycle and avoid heated dry.
3
Shake out excess water and allow to air dry in a vertical position. Ensure parts are dry before
reassembly.
4
To reassemble, fit the frontpiece on the end of the chamber and twist firmly until securely locked
into position. Center the alignment feature (C) on the backpiece with the Flow-Vu* Inhalation
Indicator (A), as shown. Press firmly to attach the backpiece.
CLEANING INSTRUCTIONS
A
Flow-Vu
*Inhalation Indicator
B
Frontpiece
C
Alignment Feature
D
Backpiece
C
D
B
Notes
• Do not boil or sterilize.
• Product should be replaced after 12 months of use.
• This product contains no latex.
• Do not share this medical device.
• If you notice medication build-up in your chamber, wash the inside of the chamber gently with a soft cloth.
• Dishwashing with overly dirty dishes is not recommended.
• If cleaning in a dishwasher use a rinse aid.
Cautions
• Do not leave the chamber unattended with children. This is not a toy.
• Product may be permanently damaged if boiled, sterilized or cleaned in a dishwasher at a temperature
above 70°C.
For optimum performance you should replace
your chamber every 12 months.
34
2
1